- ページ 12

シュレッダー Argo Wallner RS6600-BのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Argo Wallner RS6600-B 16 ページ。

iNstalla tiON:

•

Unpack and set machine upright.

•

Take the machine by the holdings on each side and put it onto the horizontal surface.

•

install the plastic bag on te rack.

•

Plug in the machine.

•

The socket-outlet shall be installed near the equipment and shall be easily accessible.

FeeDiNG the PaPer

1. Please check the voltage of your shredders carefully before using and then plug in and

press the switch, the power light is now on.

2. Feed the paper into the proper entry and the machine will start automatically. When

the shredding will be over it will stop automatically.

3. if you want to stop shredding the paper, please set it to reverse. The machine will

reverse automatically and turn back the papers.

caUtiON:

it is forbidden to place more sheets of paper then the maximum amount indicated by the

producer.

if the machine will be overloaded, then please proceed according to the information given

in the "paper jam" section.

FeeDiNG creDit carDs/cDs

1. Plug in the machine.

2. Feed the credit card/ cd into the proper entry and the machine will start automatically.

caUtiON:

Never attempt to shred more than one credit card/cd at a time or the shredder will jam.

Never attempt to shred BOTh paper and credit cards/cds at the same time. doing so will

damage the shredder.

mOtOr PrOtectiON

The shredder is equipped with a motor overload device.

after 30 minutes of continuous work allow the unit to cool for 30 minutes before restarting.

cUtter OiliNG iNstrUctiONs

To ensure proper operation and function, periodic oiling of the cutting system is required.

Failure to oil your cutting system could result in reduced sheet capacity performance,

excess noise, paper jams and possibly machine failure. Oil your cutters every time you

empty the basket, if excess squeaking and rubbing noise is coming from the machine or if

the shredders sheet capacity has diminished. squeeze the lubricant across the full width of

the cutters. Press the start button, insert paper into sensor to activate the cutting system

forward for 3 seconds. Then press „reV" to make shredder reverse for 3 seconds. alternate

between forward and reverse at least three times or until all paper clears the cutters.