- ページ 8

デジタルカメラ Sony SLT-A65V &alphaのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Sony SLT-A65V &alpha 36 ページ。 Interchangeable-lens digital camera with built-in flash
Sony SLT-A65V &alpha にも： パンフレット＆スペック (10 ページ), 仕様 (35 ページ), 限定保証 (1 ページ), 訂正 (2 ページ), 仕様 (2 ページ), 機能マニュアル (3 ページ)

ページを印刷する
Sony SLT-A65V &alpha サービスマニュアル
Ver. 1.2 2012.04
The changed portions from
Ver. 1.1 are shown in blue.
1-6. METHOD FOR REPLACING THE AS SLIDER B ASSY
Removal Procedure
(1) Remove the spring.
Spring
(2) Remove the solder on the enamel wires at two places.
Solder
Solder
(3) Remove the flexible board from the AS Slider B Assy.
Flexible Board
(4) Remove the two screws.
(5) Remove the AS Unit Holder Ball.
AS Unit Holder Ball
(6) Remove the two Ball Bearings.
Ball Bearing
Ball Bearing
SLT-A65/A65K/A65L/A65M/A65V/A65VK/A65VL/A65VM/A65VX/A65VY/A65X/A65Y_L2
(7) Remove the Cap SPs (for Pitch and Yaw).
Cap SP
(8) Remove the Caps (for Pitch and Yaw).
Cap
(9) Remove the AS Slider A Assy.
It can be done easily if A is removed beforehand.
A
AS Slider A Assy
(10) Remove the AS Slider B Assy.
It can be done easily if B is removed beforehand.
B
AS Slider B Assy
(11) Remove the three Ball Bearings.
Ball Bearing
Assembly Procedure
Note: Make sure to perform the assembly procedures after assembling the AS Holder Actuator Assy.
The assembly procedure is the reverse of the removal procedure.
Apply grease to the portions indicated below.
* After applying grease, attach the Ball Bearings.
Ball Bearing
G G-15
G G-15 and G G-116
AS Slider B Assy
* After applying grease, attach the Ball Bearings.
Ball Bearing
G G-15
Ball Bearing
G G-15
1-4
– ENGLISH –