- ページ 14

シュレッダー Argo WALLNER XD 805CDのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Argo WALLNER XD 805CD 16 ページ。

ページを印刷する

PROBLEM SOLVING

problems

No operation

No operation after

long time operation

Stop at shredding

Excess squeaking

and rubbing noise

Paper jam

MALFUNCTION / MAINTENANCE

If any faults should appear, please pass the machine along with the warranty card to the

seller or closest authorised dealer. The machine might be passed further, thus the user sho-

uld maintain the original and complete packaging. In cases when the machine is passed for

repair in a not original or incomplete package, the risks of further damages that might arise

in transportation are on the user's side. Thus, in such a case, it is in the user's best interest

to make the best possible replacement packaging.

checklists

The power plug is properly

inserted to main supply?

Switch is set at (I) AUTO

position?

Switch at (I) AUTO position but

power light off?

Basket at stand but power light

off?

No operation when insert paper?

Checked above, but still no

operation and no power light?

Power lamp is on?

Machine was continuously

shredding for a longer time?

Without oiling to the cutting

system periodically,

- squeaking and rubbing noise at

shredding may appear.

- Exceeding the shredding

capacity

- The paper is not fed squarely

into the feed opening.

solutions

Fully put the power plug to the

outlet.

Set switch to (I) AUTO position

for operation.

Check if the basket is out of

stand. Put basket back to stand.

Take the basket out, check the

plug and put it back to place.

Paper should be inserted to

trigger the sensor at center.

Send back to your local service

for repair.

Unplug the machine from

main supply. Allow to cool

down to room temperature

and resuming operation.

Unplug the machine from

main supply. Allow to cool

down to room temperature

and resuming operation.

Perform the cutter oiling

instruction to lubricate the

cutting system.

Set switch to „REV" for reverse

running and frees excess

paper. Then set to (I) AUTO for

cutting the remainder of paper

left in the cutting system.

If serious jam occurred, send

back to local service for repair.