- ページ 5

デジタルカメラ Sony VENICE MPC-3610のPDF 更新マニュアルをオンラインで閲覧またはダウンロードできます。Sony VENICE MPC-3610 17 ページ。 Digital motion picture camera

ページを印刷する

000 5

Version Upgrade using

Recovery Mode (Forced

Version Upgrade)

If the user version upgrade fails, a problem may

have occurred in internal memory. The problem in

internal memory may also have occurred due to

another error. When a problem in internal memory

occurs, an error may be issued or the MPC-3610

may not turn on. In such cases, you can forcibly

write the software to the MPC-3610 using recovery

mode. The MPC-3610 will operate normally once

the problem is resolved.

[Notes]

ˎ Executing the procedure in this section will restore the

MPC-3610 software to factory defaults, and user settings

will be lost. User settings are maintained in a normal

version upgrade, so you should upgrade from the setup

menu.

ˎ Always connect an AC adaptor (AC-DN2B, AC-DN10)

when upgrading. If a battery pack is attached at the

same time, the upgrade will continue if the AC adaptor is

subsequently disconnected.

ˎ If the problem persists after recovery using this function,

contact a Sony service representative.

Required item

Prepare an SD card or SDHC card on which the

version upgrade data is saved.

Procedure

Insert the SD card into the MPC-3610.

[Note]

Set the power switch of the MPC-3610 to the OFF

position, and then insert the SD card.

Press and hold the MENU button together

with the CLIPS and ASSIGN 2 buttons on the

Assistant side, and set the power switch to the

ON position.

The REC lamp of the MPC-3610 starts flashing

and the software recovery begins.

When finished, the REC lamp stops flashing

and the MPC-3610 automatically restarts.

[Notes]

ˎ When the REC lamp starts flashing, release the

buttons.

ˎ The version upgrade process using recovery mode

takes about 45 minutes.

ˎ The version upgrade progress may not be displayed

depending on the state of the unit.

Turn the MPC-3610 off.

Remove the SD card from the MPC-3610.

Turn the MPC-3610 on, and check that the unit

starts normally.

Check that the version has been updated (see

"Checking the Existing Version").