For AMI Spindle Control systems, spindle information is now displayed below the Z axis field in
the DRO screen. Also, the active/programmed spindle RPM can be quickly set by pressing the
black axis key directly to the right of the spindle display area.
Added ability to edit G code values for addresses R, D, U & W in drilling cycles; previously, it
was not possible to edit the values for addresses.
G2
It is now possible to send remote assistance requests from a MILLPWR
system to a service
agent whom use Remote Diagnostics PC software.
Enhanced the Repeat step to also support array and frame patterns.
A Redraw softkey (F6) has been added when in the View form dialogue. Redraw performs the
same as the decimal point hot-key. In addition, both methods now re-draw graphics when
pressed.
Enhanced the Change Steps feature to allow changes to Z Pass and Z Peck.
All of the settings in the View dialog are now saved and restored upon reboot, with the
exception of Pan, Zoom, Rotate, and Dry Run Speed.
Programming of the "staging" point for custom pockets is now optional. Moves to this point are
eliminated when no location is provided. If the "staging" point is programmed, moves to this
location at the start and end of the step are still executed.
The PLC has been updated. Any OEM/User customizations to the PLC will need to be
reintegrated into the new PLC project.
The graphics ruler is now also displayed while running a program in the 2D Line View.
Added support for setting a datum during single cycles.
Soft travel limit messages updated to indicate which limit was exceeded.
The NcKernel base was updated to Milestone 10 Service Pack 4.
These errors have been corrected:
Corrected possible tool path issues when using repeat/rotate/mirror steps.
Removed the option to delay the required reboot after changing settings in the Network Settings
dialog, as delaying it could cause unexpected issues.
AUX Function step does not break path continuity when it neighbors a Blend step.
ページを印刷する