- ページ 33

ステレオシステム Sony 3-287-077-14(2)のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Sony 3-287-077-14(2) 48 ページ。 Sony mini hi-fi component system operating instructions

ページを印刷する

Others

Troubleshooting

Make sure the power cord and

speaker cords are correctly and

firmly connected.

Find your problem in the checklist

below, and take the indicated

corrective action.

If the problem persists, contact your

nearest Sony dealer.

Note that if service personnel changes

some parts during repair, these parts

may be retained.

If the STANDBY indicator flashes

Immediately unplug the power cord,

and check the following items.

• If your system has a voltage selector,

is the voltage selector set to the

correct voltage?

• Are you using only the supplied

speakers?

• Is anything blocking the ventilation

holes on the back of the unit?

After checking the above items and

fixing any problems, plug in the power

cord again and turn on the system. If

the STANDBY indicator still flashes,

or if the cause of the problem cannot

be found even after checking all the

above items, consult your nearest

Sony dealer.

General

The display starts flashing as soon as

you plug in the power cord even

though you have not turned on the

system.

• Press DISPLAY once while the system

is turned off. The demonstration

disappears.

Sound comes from one channel,

or the left and right volumes are

unbalanced.

• Place the speakers as symmetrically as

possible.

• Connect only the supplied speakers.

Severe hum or noise.

• Move the system away from sources of

noise.

• Connect the system to a different wall

socket.

• Install a noise filter (available

separately) to the power cord.

• Turn off the surrounding electrical

equipment.

The remote does not function.

• Remove any obstacles between the

remote and the remote sensor on the

unit, and position the unit away from

fluorescent lights.

• Point the remote at the system's sensor.

• Move the remote closer to the system.

CD/MP3 player

The sound skips, or the disc will not

play.

• Wipe the disc clean.

• Move the system to a location away

from vibration (for example, on top of a

stable stand).

• Move the speakers away from the unit,

or place them on separate stands. At

high volume, speaker vibration may

cause the sound to skip.

Play does not start from the first

track.

• Press PLAY MODE repeatedly until

both "PGM" and "SHUF" light off in

the display to return to normal play.

Continued