- ページ 15

ネットワーク・ハードウェア Cisco APP-LSSのPDF インストールとアップグレードをオンラインで閲覧またはダウンロードできます。Cisco APP-LSS 32 ページ。 Fddi card and appliques

Figure 9

Thumbscrews (2)

Note

Installing the C2FCIT Card

Following is the procedure for installing the C2FCIT card:

Step 1

Caution

previously.

Step 2

Step 3

Note

pushing the card into the slot, ensure that the card is aligned with the ciscoBus and Multibus slots

and that the chassis is ﬁrmly mounted on a stable surface.

Chassis Front and Top Panels

To reassemble the chassis, reverse all steps.

Slip on an ESD-preventive wrist strap and connect it to the chassis as described in

"Preventing Electrostatic Discharge Damage" on page 8.

To avoid possible equipment failure, follow the ESD-prevention procedures described

Grasp the C2FCIT card ejector levers and position the card with the component side up and

the bus edge away from you. Handle the card as little as possible, and when you do handle

it try to make contact with only the ejector levers and card edges.

Place the bus edge of the C2FCIT card into the predetermined ciscoBus slot in the system

card cage. For slot priority guidelines, refer to the section "Slot Priority" on page 9.

You will have to use a moderate amount of force to push the card into the slot properly. Before

Installing and Upgrading the CSC-C2FCIT FDDI Card and Appliques

Cover screws (7)

Access panel

Installing Cards and Appliques