- ページ 34
ステレオシステム Sony MEX-N5100BTのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Sony MEX-N5100BT 38 ページ。 Bluetooth audio system
Sony MEX-N5100BT にも： 取扱説明書 (42 ページ)
ページを印刷する
F:\0918\4548379111\4548379111MEXN5100BTUC\01GB-MEXN5100BTUC\040CD.fm
010COV.book Page 34 Thursday, September 18, 2014 10:49 AM
Making connections
To a common ground (earth) point
First connect the black ground (earth) lead, then
connect the yellow and red power supply leads.
To the +12 V power terminal which is
energized at all times
Be sure to first connect the black ground (earth)
lead to a common ground (earth) point.
To the +12 V power terminal which is
energized when the ignition switch is set to
the accessory position
If there is no accessory position, connect to the
+12 V power (battery) terminal which is
energized at all times.
Be sure to first connect the black ground (earth)
lead to a common ground (earth) point.
To the power antenna (aerial) control lead or
the power supply lead of the antenna (aerial)
booster
It is not necessary to connect this lead if there is
no power antenna (aerial) or antenna (aerial)
booster, or with a manually-operated telescopic
antenna (aerial).
To AMP REMOTE IN of an optional power
amplifier
This connection is only for amplifiers and a
power antenna (aerial). Connecting any other
system may damage the unit.
For MEX-N5100BT:
To a car's illumination signal
Be sure to first connect the black ground (earth)
lead to a common ground (earth) point.
Subwoofer Easy Connection
You can use a subwoofer without a power amplifier
when it is connected to a rear speaker cord.
Note
Use a subwoofer with an impedance of 4 to 8 ohms,
and with adequate power handling capacities to avoid
damage.
Memory hold connection
When the yellow power supply lead is connected,
power will always be supplied to the memory circuit
even when the ignition switch is turned off.
34
GB
Speaker connection
Before connecting the speakers, turn the unit off.
Use speakers with an impedance of 4 to 8 ohms,
and with adequate power handling capacities to
avoid damage.
Installing the microphone (MEX-
N5100BT only)
To capture your voice during handsfree calling, you
need to install the microphone .
Clip (not supplied)
Cautions
It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
If airbags or any other shock-absorbing
equipment is in your car, contact the store where
you purchased this unit, or the car dealer, before
Front speaker
installation.
Note
Before attaching the double-sided tape , clean the
surface of the dashboard with a dry cloth.
Subwoofer
masterpage: Left
MEX-N5100BT/MEX-N4100BT
4-548-379-11(1)