- ページ 25

ステレオシステム Sony MHC-RG80のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Sony MHC-RG80 28 ページ。 Mini hi-fi component system

ページを印刷する

Additional Information

Precautions

On operating voltage

Before operating the unit, check that the operating

voltage of your unit is identical with the voltage of

your local power supply.

On safety

• The unit is not disconnected from the AC power

source (mains) as long as it is connected to the wall

outlet, even if the unit itself has been turned off.

• Unplug the unit from the wall outlet (mains) if it is

not to be used for an extended period of time. To

disconnect the cord (mains lead), pull it out by the

plug. Never pull the cord itself.

• Should any solid object or liquid fall into the

component, unplug the unit and have the

component checked by qualified personnel before

operating it any further.

• The AC power cord must be changed only at the

qualified service shop.

On placement

• Place the unit in a location with adequate

ventilation to prevent heat build-up in the unit.

• Do not place the unit in an inclined position.

• Do not place the unit in locations where it is:

— extremely hot or cold

— dusty or dirty

— very humid

— vibrating

— subject to direct sunlight

On operation

• If the unit is brought directly from a cold to a warm

location, or is placed in a very damp room, moisture

may condense on the lens inside the CD player.

Should this occur, the unit will not operate properly.

Remove the CD and leave the unit turned on for

about an hour until the moisture evaporates.

• When you move the unit, take out any discs.

If you have any questions or problems concerning

your unit, please consult your nearest Sony dealer.

Notes on CDs

• Before playing, clean the CD with a cleaning cloth.

Wipe the CD from the center out.

• Do not use solvents.

• Do not expose the CD to direct sunlight or heat

sources.

Note on CD-R/CD-RW playback

Discs recorded on CD-R/CD-RW drives may not be

played back because of scratches, dirt, recording

conditions or the drive's characteristics. Besides, the

discs, which are not yet finalized at the end of

recording, cannot be played back.

10ADD_MHC-DX70/DX50/RG80.p65 E

To save a tape permanently

To prevent a tape from being accidentally recorded

over, break off the cassette tab, refer to attached

instruction with the tape.

Cleaning the cabinet

Use a soft cloth slightly moistened with mild

detergent solution.

Before placing a cassette in the tape

deck

Take up any slack in the tape. Otherwise the tape may

get entangled in the parts of the tape deck and become

damaged.

When using a tape longer than 90

minutes

The tape is very elastic. Do not change the tape

operations such as play, stop, and fast-winding etc.

frequently. The tape may get entangled in the tape

deck.

Cleaning the tape heads

Clean the tape heads after every 10 hours of use.

Make sure to clean the tape heads before you start an

important recording or after playing an old tape. Use

separately sold dry-type or wet-type cleaning cassette.

For details, refer to the instructions of the cleaning

cassette.

Demagnetizing the tape heads

Demagnetize the tape heads and the metal parts that

have contact with the tape every 20 to 30 hours of use

with a separately sold demagnetizing cassette. For

details, refer to the instructions of the demagnetizing

cassette.

Troubleshooting

If you run into any problem using this unit, use

the following check list.

First, check that the power cord is connected

firmly and the speakers are connected correctly

and firmly.

Should any problem persist, consult your

nearest Sony dealer.

General

The display starts flashing as soon as you plug

in the power cord even though you haven't

turned on the power (demonstration mode).

Press DISPLAY when the power is turned off.

The demonstration mode appears automatically the

first time you plug in the power cord or if there is a

power outage.

MHC-DX70/DX50/RG80 4-232-650-13 (1)

continued

3/13/01, 4:51 PM