ページを印刷する
————————
Specifications
For the U.S.A. model
AUDIO
POWER
SPECIFICATIONS
POWER OUTPUT AND
TOTAL HARMONIC
DISTORTION:
With 6 ohm loads, both
channels driven, from 40 —
20,000 Hz; rated 100 watts
per channel minimum RMS
power, with no more than
0.9 % total harmonic
distortion from 250
milliwatts to rated output.
CD player section
System
Compact disc digital
audio system
Laser
Semiconductor laser
(A=780 nm)
Emission
duration: continuous
Max 44.6 upW*
*This output is the
value measured at a
distance of 200 mm
from the objective lens
surface on the Optical
Pick-up Block with,
7 mm aperture.
780 — 790 nm
Laser output
Wavelength
Frequency response
2 Hz - 20 kHz (+1.0 dB)
Signal-to-noise ratio
More than 80 dB
Dynamic range
— More than 90 dB
CD OPTICAL DIGITAL OUT
(Square optical connector jack, rear panel)
Wavelength
600 nm
Output Level
~18
dBm
Tuner section
FM stereo, FM/AM superheterodyne
tuner
FM tuner section
Tuning range
87.5 — 108.0 MHz
(100 kHz. step)
Antenna
FM lead antenna
Antenna terminals
75 ohm unbalanced
Intermediate frequency
10.7 MHz
AM tuner section
Tuning range
AM:
— 530- 1,710 kHz
(with the AM tuning
interval set at 10 kHz)
531 - 1,710 kHz
(with the AM tuning
interval set at 9 kHz)
Antenna
AM loop antenna,
External antenna
terminals
Intermediate frequency
450 kHz
Amplifier section
Continuous RMS power output
U.S.A. model:
(FRONT)
100 W + 100 W (6 ohms
at 40 — 20,000Hz, 0.9% THD)
120 W +120 W
(6 ohms at 1 kHz, 5% THD)
(CENTER)
30 W
(8 ohms at 1 kHz, 5% THD)
(REAR)
15W+15W
(8 ohms at 1 kHz, 5% THD)
Canadian model:
(FRONT)
120 W +120 W
(6 ohms at 1kHz, 5% THD)
(CENTER)
30 W
(8 ohms at 1 kHz, 5% THD)
(REAR)
1I5W+15W
(8 ohms at 1 kHz, 5% THD)
Inputs
VIDEO/MD IN (phono jacks):
voltage 250 mV/450 mV
impedance 47 kilohms
MIX MIC (phone jacks):
sensitivity 1 mV,
impedance 10 kilohms
Outputs
VIDEO/MD OUT (phono jacks):
voltage 250 mV/450 mV
impedance 1 kilohms
PHONES (stereo phone jack):
accepts headphones of 8 ohms
or more.
FRONT SPEAKER:
accepts impedance of 6 to 16
ohms.
CENTER SPEAKER:
accepts impedance of 8 to 16
ohms.
REAR SPEAKER:
accepts impedance of 8 to 16
ohms.
SUPER WOOFER:
voltage 250 mV
impedance | kilohms
Tape player section
Recording system
4-track 2-channel] stereo
Frequency response
(DOLBY NR OFF)
40 ~ 13,000 Hiz (+3 dB),
using Sony TYPE | cassette
40 — 14,000 Hz ( +3 dB),
using Sony TYPE If cassette
40 — 15,000 Hz (43 dB)
using Sony TYPE IV cassette
Wow and flutter
0.1% WRMS +0.3% (DIN)
Speaker section
Front speakers (SS-EX55P)
Speaker system
3-wav, bass-reflex tvpe
Speaker units
Woofer:
17cm (6"'/, in.) dia.,
cone type
Tweeter:
5em (1 "/,, in.) dia.,
cone tvpe
Super Tweeter:2 cm (7°/,, in.) dia.,
dome type
Rated impedance
6 ohms
Dimensions
Approx. 225 x 410 x 295
mm (87/,x 16'/,x 11
*/, in.) (w/h/d)
Mass
Approx. 5.6 kg (12 lb. 5
oz.) net per speaker
Center speaker (SS-CN14)
Speaker system
Full range,
magnetically shielded
8 em (3 '/, in.) dia.,
cone type x 2
Enclosure type
Bass reflex
Rated impedance
8 ohms
Sensitivity
88 dB (1W, 1m)
Frequency range
95 ~ 20,000 Hz
Dimensions
Approx. 280 x 110 x 140
mm (11x
4°/,.x5'/,
in.) (w/h/d) incl. front
grille
Mass
Approx. 1.7 kg (3 Ib. 12
02.)
Speaker unit
Rear speakers (SS-SR12)
Speaker system
Full range
Speaker unit
8 cm (3 '/, in.) dia.,
cone type
Enclosure type
Bass reflex
Rated impedance
8 ohms
Sensitivity
87 dB (WW, 1m)
Frequency range
95 — 20,000 Hz
Dimensions
Approx. 110 x 160 x 140
mm (4*/,,x6°/,, x5
'7, in.) (w/h/d) incl.
front grille
Mass
Approx. 740 g (1 Ib. 10
oz.) per speaker
Supplied accessories
AM loop antenna (1)
Remote RM-SE3AV (1)
Sony SUM-3 (NS)-batteries (2)
FM lead antenna (1)
Speaker cords (5)
General
Power requirements
120 V AC, 60 Hz
Power consumption
U.S.A. model: 260 watts
Canadian model: 350 VA
Dimensions
Amplifier/Tuner section:
Approx. 280 x 205 x 345 mm
(11x 8'/,.x 13°/, in.) (w/h/d)
Tape/CD section:
Approx. 280 x 205 x 350 mm
(Ix 8'!/,,x 13 ¢/, in) w/h/d)
For Your Information
| 3 1