- ページ 5

ネットワーク・ハードウェア Cisco ASA 5516-XのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco ASA 5516-X 9 ページ。 Threat defense reimage guide
Cisco ASA 5516-X にも：ハードウェア・インストール・マニュアル (32 ページ), クイック・スタート・マニュアル (8 ページ), 簡単セットアップマニュアル (11 ページ), ソフトウェアマニュアル (37 ページ), マウント＆コネクト (6 ページ), マニュアル (14 ページ)

ページを印刷する

Cisco Firepower Threat Defense for the ASA 5508-X and ASA 5516-X Using Firepower Management Center Quick Start Guide

6. Configure the Device for Firepower Management

The first time you access the CLI, a setup wizard prompts you for basic network configuration parameters that are

required to setup your Firepower Threat Defense device and to register with a Firepower Management Center.

Note that the management IP address and associated gateway route are not included on the Firepower

Management Center web interface in the list of interfaces or static routes for the device; they can only be set by

the setup script and at the CLI.

Before You Begin

Ensure that you connect a data interface to your gateway device, for example, a cable modem or router. For edge

deployments, this would be your Internet-facing gateway. For data center deployments, this would be a back-bone

router.

The Management interface must also be connected to a gateway through which the Internet is accessible. System

licensing and database updates require Internet access.

Procedure

Connect to the device, either from the console port or using SSH, for example.

—

For a device attached to a monitor and keyboard, log in at the console.

—

For access to the management interface of the device, SSH to the Management interface's default IPv4

address: 192.168.45.45.

When the Firepower Threat Defense system boots, a setup wizard prompts you for the following information

required to configure the system:

—

Accept EULA

—

New admin password

—

IPv4 or IPv6 configuration

—

IPv4 or IPv6 DHCP settings

—

Management port IPv4 address and subnet mask, or IPv6 address and prefix

—

System name

—

Default gateway IPv4, IPv6, or both

—

DNS setup

—

HTTP proxy

—

Management mode

Review the setup wizard settings. Defaults or previously entered values appear in brackets. To accept

previously entered values, press Enter.

Example:

Please enter 'YES' or press <ENTER> to AGREE to the EULA:

System initialization in progress.

You must change the password for 'admin' to continue.

Enter new password:

Confirm new password:

You must configure the network to continue.

You must configure at least one of IPv4 or IPv6.

Do you want to configure IPv4? (y/n) [y]: y

6. Configure the Device for Firepower Management

Please stand by.