- ページ 22
ステレオシステム Sony SRS-X88のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Sony SRS-X88 40 ページ。 Personal audio system
Sony SRS-X88 にも： 取扱説明書 (28 ページ), スタートアップマニュアル (2 ページ), 取扱説明書 (41 ページ), スタートアップマニュアル (2 ページ)
ページを印刷する
SRS-X88
2-17. CARD WLAN/BT COMBO
Note 1: Be sure to replace the complete NETWORK board and card WLAN/
BT combo at the same time. Be sure to also follow "NOTE OF RE-
PLACING THE COMPLETE NETWORK BOARD AND CARD
WLAN/BT COMBO" on page 3 during replacement.
Note 2: When replacing the card WLAN/BT combo, refer to "CHECKING
OF NETWORK CONNECTION" on page 3.
3 Remove the card WLAN/BT combo
block in the direction of the arrow.
8 two sheets (1)
7 holder (WI-FI)
2 screw
(BTTP M2.6
9 card WLAN/BT combo
Note 3: When affixing the tape, be careful
that it does not obstruct the hole.
card WLAN/BT
combo
tape
20 mm
(sub material)
sheet (1)
guide line
card WLAN/BT
combo
22
1 tape
(sub material)
A
8)
A
5 antenna
connector
(CON4)
6 screw
(BVTT2.6
4)
guide line
heat sink (lower)
sleeve ferrite
clamp (FC1)
guide line
sheet (1)
card WLAN/BT
combo
4 card WLAN/BT combo
connector
1 tape
(sub material)
tape
(sub material)
Insert the connector straight into the interior.
There is a possibility that using this unit without
the connector correctly installed will damage it.
OK
Insert straight into
Insert only part way.
the interior.
connector
connector
connector
connector
card WLAN/BT combo
Note 4: The antenna wire must not
touch the shield portion.
antenna wire
NG
NG
Insert at a slant.
connector
connector