- ページ 11
ステレオシステム Sony ST-SP55のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Sony ST-SP55 16 ページ。 Micro hi-fi component system
- 1. 1 Service Note
- 2. 2 General
- 3. 3 Diagrams
- 3. Circuit Boards Location
- 3. Block Diagram
- 3. Schematic Diagram - Main Section
- 3. Printed Wiring Board - Main Section
- 3. Schematic Diagram - Panel Section
- 3. Printed Wiring Board - Panel Section
- 3. IC Pin Functions
- 3. IC Block Diagram
- 3. Table of Contents
- 3. Case and Front Panel
- 4. 4 Exploded View
- 5. 5 Electrical Parts List
www.freeservicemanuals.info
This unit cannot be repaired by itself.
When repairing, connect the whole system except for the speaker.
CD Text Display
• This unit displays CD text.
Text is displayed for the first 50 track only and will not be displayed from the 51st track onwards. Do not suspect a fault in this case.
In some cases, some special characters will not be displayed and may be replaced by other characters. Do not suspect a fault in this case.
Cold Reset
• The cold reset clears all data including preset data stored in the RAM to initial conditions. Execute this mode when returning the set to the
customer.
Procedure :
1. When the power ON, press the ?/1 button (TA) while pressing the TUNING MODE button (ST) and ML buttons (CDP) together.
2. "COLD RESET" is displayed on the fluorescent indicator tube and reset is executed.
Hot Reset
• This mode reset the preset data kept in the memory. The hot reset mode functions same as if the power cord is plugged in and out.
Procedure :
1. When the power ON, press the ?/1 button (TA) while pressing the TUNING MODE button (ST) and lm buttons (CDP) together.
2. Turn off the unit and reset is executed.
GC Test Mode
Procedure :
1. When the power ON, press the ?/1 button (TA) while pressing the TUNING MODE button (ST) and PLAY MODE buttons (CDP)
together.
2. LCD are all turned on.
3. Press TUNING MODE button (ST) to enter the model destination indecation mode. "SP55 CE2" or "SP55 ASIA2" appears.
4.
Every pressing of TUNING MODE button (ST) changes the display in the following order.
MC Version t CD Version t ST Version t TC Version t TA Version t TM Version t model destination display.
5.
Press DISPLAY button (ST) and the date appears as " 00615a "
Every pressing of DISPLAY button (ST) changes the display in the Version display and model destination display.
6. Press TUNER/BAND button (ST) to enter the key check mode.
7. In the key check mode, the fluorescent indicator tube displays "Key 0 Vol 0". Each time a button is pressed, "Key" value increases.
However, once a button is pressed, it is no longer taken into account.
"Vol" Value increases like "1, 2, 3 ..." if rotating VOLUME knob (TA) in the clockwise direction, or decreases like "0, 9, 8 ..." if rotating
in the counterclockwise diretion.
8. To exit from this mode, disconnect the power cord.
1
(Remote sensor)
2
Display window
3
TUNING +/– button
4
TUNER/BAND button
5
TUNING MODE button
6
DISPLAY button
05/28/2012
SECTION 1
SERVICE NOTE
SECTION 2
GENERAL
1
2
6
World of Free Manuals
3
5
4
3