- ページ 14

ステレオシステム Sony Walkman MZ-R900のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。Sony Walkman MZ-R900 50 ページ。 Service manual
Sony Walkman MZ-R900 にも：取扱説明書 (20 ページ), 仕様 (2 ページ), 限定保証 (1 ページ), 取扱説明書 (13 ページ)

ページを印刷する

MZ-R900

5. The display changes a shown below each time the

[JOG LEVER $L% ]

(up) key or

commander is pressed.

• Address & Adjusted Value Display

Remote commander LCD display

011 C 6 8 S 0 1

address

item number

• Jitter Value & Adjusted Value Display

Remote commander LCD display

011 O F F J 0 1

jitter value

item number

• Block Error Value & Adjusted Value Display

Remote commander LCD display

011 0 6 3 B 0 1

block error value

item number

• ADIP Error Value & Adjusted Value Display

Remote commander LCD display

011 0 5 9 A 0 1

ADIP error value

item number

• Item Title Display

Remote commander LCD display

011 L r e f P w 0 1

item title

item number

However in the power mode (item number 700's), only the

item is displayed.

6. Quit the manual mode, and press the

test mode (display check mode).

Overall Adjustment Mode

Mode to adjust the servo automatically in all items.

Normally, automatic adjustment is executed in this mode at the

repair.

For further information, refer to "Section 5 Electrical Adjustments"

(see page 17).

[DISPLAY]

key on the remote

adjusted value

key to return to the

Self-Diagnosis Result Display Mode

This set uses the self-diagnostic function system in which if an

error occurred during the recording or playing, the mechanism

control block and the power supply control block in the

microcomputer detect it and record its cause as history in the

nonvolatile memory.

By checking this history in the test mode, you can analyze a fault

and determine its location.

Total recording time is recorded as a guideline of how long the

optical pickup has been used, and by comparing it with the total

recording time at the time when an error occurred in the self-

diagnosis result display mode, you can determine when the error

occurred.

Clear both self-diagnosis history data and total recording time, if

the optical pickup was replaced.

• Self-Diagnosis Result Display Mode Setting Method

1. Setting the test mode (see page 12).

2. In the display check mode, press the

[DISPLAY]

key or

key on the remote commander activates the

self-diagnosis result display mode where the LCD display as

shown below.

Remote commander LCD display

0XX 1 0 0 0 0

history code

Total recording time when error occurred

error display code

3. Then, each time the

key is pressed, LCD display descends

by one as shown below. Also, the LCD display ascends by one

when the

key is pressed.

0XX 1 * * * *

0XX N * * * *

0XX N 1 * * * *

0XX N 2 * * * *

0XX R _ * * * *

: Error code

* * * * : Total recording time

[JOG LEVER $L% Q]

If the

(up) key or the

remote commander is pressed with this display, the LCD switches

to the simple display mode.

4. Quit the self-diagnosis result display mode, and press the

to return to the test mode (display check mode).

[JOG LEVER $L% ]

[DISPLAY]

key on

(up)

key