- ページ 26

ネットワーク・ハードウェア Cisco ASR 9922のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Cisco ASR 9922 44 ページ。 Replacing cisco asr 9000 series router components

Removing Cards from the Chassis

Note

The BPID board monitors OIR by counting the number of card insertions for each slot and saving that

information in non-volatile memory. OIR monitoring is done for all line cards, the RSP, the RP, and the fan

trays. See

Removing Cards from the Chassis

Follow these steps to remove and replace an RSP card, RP card, FC, or LC from the card cage:

Procedure

Step 1

Power down the card using either of the two processes:

a) Use the CLI to power down the card.

Router# admin

Router(admin)# config

Router(admin-config)# hw-module power disable location location

Router(admin-config)# commit

Router(admin-config)# exit

The location is specified in rack/slot/cpu notation. For example, hw-module power disable location

0/1/CPU0.

b) Disengage the card from the back plane by performing Step 3a, 3b, and 3c. Leave the card inside the slot.

Once the card is powered down wait 10 minutes for the line card to cool down below a temperature suitable

to touch

Step 2

Disconnect any cables from the card.

a) Identify the type of line card and its slot number. Write this information down before you disconnect the

cables. You'll need this information when you reinstall the line cards.

b) Identify the line card cable and its port connection. Label the cable with this information.

c) Starting with the port of the line card farthest from the cable management bracket, disconnect the interface

cable connectors from each of the line card ports.

d) Carefully remove the cables from the cable-management bracket attached to the front panel of the line

card.

e) (Optional) Use the 6-inch long number 2 Phillips screwdriver to a torque of 10 +/–1 in-lb to loosen the

captive screw that secures the cable-management bracket to the line card and remove the cable-management

bracket from the line card.

f) Carefully remove the cables from the horizontal cable management tray at the top of the chassis or side

cable management brackets (Cisco ASR 9006 Router) and carefully place the cable bundle out of the way.

Step 3

Remove the card:

a) Use the 6-inch long number 2 Phillips screwdriver to loosen the captive screws at each end of the card

front panel.

b) On the FC and LC push in both ejector lever release buttons.

c) Pivot the ejector levers to unseat the card from the backplane connector.

d) Slide the card out of the slot and place it directly into an antistatic bag or other ESD-preventive container.

Replacing Cisco ASR 9000 Series Router Components

OIR Monitoring, on page 3

Replacing Cisco ASR 9000 Series Router Components

for more information.