- ページ 17

ネットワーク・ハードウェア Cisco C1101-4PのPDF インストールと接続をオンラインで閲覧またはダウンロードできます。Cisco C1101-4P 27 ページ。 Install and upgrade internal modules and field replaceable units
Cisco C1101-4P にも：マニュアル (12 ページ)

ページを印刷する

Install and Connect the Router

Do not over-torque the screws. The recommended torque is 8 to 10 inch-lbf (0.9 to 1.1 N-m).

Note

Chassis Grounding

Warning

Connect the Chassis to Earth Ground—To reduce the risk of electric shock, the chassis of this equipment

needs to be connected to permanent earth ground during normal use. Statement 445

Warning

Only trained and qualified personnel should be allowed to install or replace this equipment Statement 1030

After you set up the router, connect the chassis to a reliable earth ground; the ground wire must be installed

in accordance with local electrical safety standards. For safety information on grounding the chassis, refer to

the chassis ground connection procedures.

1. For grounding the chassis, use a copper wire of size of 14 AWG (2 mm²) and the ground lug. These are

not a part of the accessory kit.

2. Use the UNC 6-32 screws, which have a length of about 0.25 inches.

To install the ground connection for your router, perform these steps:

1. Strip one end of the ground wire to the length required for the ground lug or terminal.

2. Crimp the ground wire to the ground lug or ring terminal, using a crimp tool of the appropriate size.

3. Attach the ground lug or ring terminal to the chassis as shown in the below figures. The screw for the

ground lug is provided. Tighten the screw; the recommended torque is 8 to 10 inch-lbf (0.9 to 1.1 N-m).

• For the ground lug—approximately 0.75 inch (20 mm)

• For user-provided ring terminal—as required

Chassis Grounding

Install and Connect the Router