- ページ 2

ラボラトリー機器 Argo Lab M2-AのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Argo Lab M2-A 3 ページ。 Analog hotplate magnetic stirrer

ページを印刷する
1 Safety instructions
•
Read the instructions carefully before use
•
Ensure that only qualified personnel using this tool
•
Do not heat flammable or highly volatile substances
•
Be very careful when you touch the heater plate. It can
reach a temperature of 340 ° C. Pay attention even when the
power has been turned off because the plate stays hot even
longer.
•
Before use, make sure the instrument is connected to an
outlet with a ground connection.
>100mm
•
Observe the minimum distance between the instruments and
between the device and the wall (minimum 10 cm).
2 Control and Display
Heating knob Stirring knob
LED Heating
LED
Stirring
Switch ON/OFF
Items
Set the desired rotation speed between 0 and 1500 rpm. The
Stirring knob
function of agitation is activated / deactivated by turning the
Stir
knob.
Set the desired temperature between room temperature and
Heating knob
340 ° C. The function of agitation is activated / deactivated
Heat
by turning the knob.
When the heating function is activated, the heating LED is
LED Heating
switched on.
When the function is activated, the stirring LED is switched
LED Stirring
on.
Switch ON/OFF
Turns on or turn off the instrument.
3 Operation
• Place the device on a stable surface, make sure the temperature control knob is set at
minimum and connect the power supply.
• Turn on the instrument.
• Turn the control knob to set the speed of the rated rotary speed in the safe speed limit
0-1500 rpm.
• Turn the temperature control knob to set the required temperature in the safe limit
0-340 ° C.
4 Faults
• In the event of instrument failure shut it down.
• Turn off the main switch ON / OFF for a few seconds and then switch on again.
• The stirring function will continue to operate at the set speed before it happened the
fault.
• The heating function will continue to operate at the set temperature before it happened
the fault.
• If the problem is not solved, call your technical service center.
Descriptions