- ページ 2

電話アクセサリー Digitone ProSeries 3のPDF 操作マニュアルをオンラインで閲覧またはダウンロードできます。Digitone ProSeries 3 16 ページ。

™

Digitone ProSeries 3 Call Blocker

Setup

Thank you for choosing Digitone's ProSeries 3 Call Blocker™ (DPS3) model for your

Personal Telephony Management. The DPS3 comes preloaded to block Anonymous,

fake Exchanges, Millions of Out of Area and Private Numbers, and Trillions of Fake

Names using Digitone's Patented matrix system. Just connect your Phones and you're

ready to go as Digitone's DPS3 can operate right out of the box. No Battery Backup

is Needed. If a power outage occurs, all program settings remain intact.

Step 1. Connect the supplied line cord to your telephone Wall jack, or cable modem

Phone jack, or VoIP adapter's Phone jack and then to the Line Port on the DPS3.

Initially, "Check Line Link" will show on the display until the Line cord is plugged into

the LINE port. Note: "Check Line Link" will also backlight the display if the Line cord

is disconnected afterwards.

Step 2. Connect your Phone or Combo Phone System to the TEL phone port of the

DPS3 and set to 3-5 rings. Before powering up the DPS3, take your phone Off-Hook to

see if you have a dial tone, if so hang-up. Note if you also have Voice Mail services

from your phone company, then set the Voice Mail Ring Count to 6 or 7 rings.

Step 3. Next, plug the small end of the Power Adapter into the port labeled 24VDC on

the DPS3, then plug in the Power Adapter into a standard AC receptacle. Your final

assembly should look like this figure below: