- ページ 20

ネットワーク・ハードウェア Cisco CWDM-OADM 1 SeriesのPDF インストレーション・ノートをオンラインで閲覧またはダウンロードできます。Cisco CWDM-OADM 1 Series 36 ページ。 Passive optical system

Connecting the CWDM Passive Optical System to Your System

Connect the single-mode fiber-optic patch cable from the CWDM GBIC or CWDM SFP transceiver to

Step 4

the OADM module EQUIPMENT connector. Connect the Tx ports to the Rx ports and the Rx ports to

the Tx ports to ensure that the system operates correctly.

Note

If you use both channels of the module, repeat

Step 5

Connect the network west backbone single-mode fiber-optic cable to the NETWORK WEST connector

Step 6

on the OADM module, and connect the east backbone single-mode fiber-optic cable to the NETWORK

EAST connector on the OADM module.

Step 7

If you are planning to monitor your network with an optical power meter or an optical spectrum analyzer,

connect your meter or analyzer to the MONITOR port on the OADM.

Connecting Cables to the CWDM 4-Channel OADM Module

Note

Make sure that the CWDM GBIC or CWDM SFP transceiver color code matches the color of the OADM

port to which it is connected.

To connect the cables to the CWDM 4-channel OADM module, follow these steps (see

Insert the CWDM GBIC transceivers or CWDM SFP transceivers into the appropriate modules on your

Step 1

switch or router system if you have not already done so. For more information on installing CWDM

GBIC or CWDM SFP transceivers, refer to the Cisco CWDM GBIC and CWDM SFP Installation Note.

Note

Cisco CWDM Passive Optical System Installation Note

If you are using CWDM SFP transceivers, use an LC-to-LC patch cable.

If you are using CWDM GBIC transceivers, you must use an SC-to-LC patch cable

(CAB-SM-LCSC-1M= or CAB-SM-LCSC-5M=).

CWDM GBIC transceivers are equipped with SC connectors. To make connections to the LC

connectors on the OADM modules, you must use an LC to SC patch cable (Cisco part number

CAB-SM-LCSC-1M= [1 meter cable], CAB-SM-=LCSC-5M= [5 meter cable], or an equivalent

patch cable).

Always use single-mode fiber-optic patch cables to connect the CWDM OADM ports to the

CWDM GBIC transceivers or CWDM SFP transceivers.

CWDM GBIC transceivers are equipped with SC connectors. To make connections to the LC

connectors on the OADM modules, you must use an LC to SC patch cable (Cisco part number

CAB-SM-LCSC-1M= [1 meter cable], CAB-SM-=LCSC-5M= [5 meter cable], or an equivalent

patch cable).

Step 4

for the second channel.

Figure

18):

78-16565-02