- ページ 12

ネットワーク・ハードウェア Cisco Firepower 4100 SeriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Firepower 4100 Series 38 ページ。 Rack-mount and ground the chassis
Cisco Firepower 4100 Series にも：製品マニュアル (17 ページ), マニュアル (8 ページ), メンテナンスとアップグレードマニュアル (20 ページ), マニュアル (36 ページ), マニュアル (8 ページ), マニュアル (42 ページ)

10-Gb Network Module

For More Information

10-Gb Network Module

The following figure shows the front panel of the 10-Gb network module (FPR4K-NM-8X10G). The

FPR4K-NM-8X10G is a single-wide module that supports hot swapping. The eight ports are numbered from

top to bottom, left to right.

Note

Figure 8: FPR4K-NM-8X10G

Overview

• See

10-Gb Network Module, on page 12

• See

40-Gb Network Module, on page 13

• See

100-Gb Network Module, on page 14

• See

Hardware Bypass Network Modules, on page 15

and the port configurations for the hardware bypass network modules.

• See

Install, Remove, and Replace the Network Module

network modules.

Make sure you have the correct firmware package and software version installed to support this network

module. For instructions on how to verify your firmware package version and to upgrade the firmware

if necessary, see the

Cisco Firepower 4100/9300 FXOS Firmware Upgrade

4100/9300 FXOS Compatibility

The FPR4K-NM-8X10G is NEBS-compliant.

You can fit four copper SFPs in either the top row of ports or the bottom row of ports. Both rows cannot

be populated at the same time, because of the port row spacing.

for a description of the 10-GB network module.

for a description of the 40-GB network module.

for a description of the two-port 100-Gb network module.

for the location and description of the LEDs,

for the procedure for removing and replacing

for the software compatibility matrix.

Overview

Guide. See

Cisco Firepower