- ページ 16

ネットワーク・ハードウェア Cisco Firepower 4110のPDF はじめにをオンラインで閲覧またはダウンロードできます。Cisco Firepower 4110 42 ページ。 Rack-mount and ground the chassis
Cisco Firepower 4110 にも：メンテナンスとアップグレードマニュアル (20 ページ), マニュアル (36 ページ), マニュアル (26 ページ), マニュアル (8 ページ), マニュアル (42 ページ)

Cabling for the Secure Firewall 3100

Figure 4: Cabling the Secure Firewall 3100

Manage the FTD device on either Management 1/1 or Ethernet 1/2. The default configuration also configures

Ethernet1/1 as outside.

• Connect your management computer to either of the following interfaces:

Note

• Connect the outside network to the Ethernet1/1 interface.

• Connect other networks to the remaining interfaces.

Getting Started

• Ethernet 1/2—Connect your management computer directly to Ethernet 1/2 for initial configuration,

or connect Ethernet 1/2 to your inside network. Ethernet 1/2 has a default IP address (192.168.95.1)

and also runs a DHCP server to provide IP addresses to clients (including the management computer),

so make sure these settings do not conflict with any existing inside network settings.

• Management 1/1—Connect Management 1/1 to your management network, and make sure your

management computer is on—or has access to—the management network. Management 1/1 obtains

an IP address from a DHCP server on your management network; if you use this interface, you must

determine the IP address assigned to the firewall so that you can connect to the IP address from

your management computer.

If you need to change the Management 1/1 IP address from the default to configure a static IP

address, you must also cable your management computer to the console port. See

Management Network Settings at the CLI, on page

Management 1/1 is a 10-Gb fiber interface that requires an SFP module.

By default, the IP address is obtained using IPv4 DHCP and IPv6 autoconfiguration, but you can set a

static address during initial configuration.

21.

Getting Started

(Optional) Change