- ページ 14

ネットワーク・ハードウェア Cisco IAD2430 SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco IAD2430 Series 34 ページ。 Integrated access device
Cisco IAD2430 Series にも：概要マニュアル (13 ページ), 概要 (16 ページ)

ページを印刷する

Wall-Mounting the Cisco IAD2430, Cisco IAD2431, and Cisco IAD2432 IADs

To wall-mount a Cisco IAD2430, Cisco IAD2431, or Cisco IAD2432 IAD, follow these steps:

Attach the short side of one bracket to the chassis, as shown in Figure 12, using two 6-32 x 1/4 slotted hex screws

Step 1

(provided). Be sure to use a plastic washer (provided) with each screw; the narrow end of the washer must fit into the

bracket slot, facing the chassis.

Caution

Be sure to use the correct screws and plastic washers for this mounting option. (See Table 1 on page 11.)

Figure 12

Attaching the Brackets for Wall-Mounting

Attach the second bracket to the other side of the chassis.

Step 2

Step 3

Attach the router to the wall by using the brackets and attachment hardware that you provide, as follows:

• You can install a starter screw in the wall, and hook the bracket keyhole over the screw. This holds the unit in place

for easy installation of the attachment screws.

• Attach both brackets to the wall.

For attaching to a wall stud, each bracket requires two number-10 wood screws (round- or pan-head) with

Note

number-10 washers, or two number-10 washer-head screws. The screws must be long enough to penetrate at

least 3/4 inch (20 mm) into the supporting wood or metal wall stud.

For hollow-wall mounting, each bracket requires two wall anchors with washers. Wall anchors and washers

Note

must be size number 10.

Figure 13 shows the orientation required for installing the Cisco IAD2430, Cisco IAD2431, or Cisco IAD2432 IADs.