- ページ 2
メディア・コンバーター Digitrax DN163A2のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Digitrax DN163A2 8 ページ。 Mobile decoder dcc plug 'n play 1.5 amp/2.0 amp peak 6 fx3 functions, 0.5 amp
ページを印刷するP P a a r r t t s s L L i i s s t t
1 DN163a2 Decoder
I I n n s s t t a a l l l l a a t t i i o o n n I I n n f f o o r r m m a a t t i i o o n n
See the Digitrax Decoder Manual for complete decoder test procedures, instal-
lation instructions, programming and technical information. Digitrax manuals
and instructions are updated periodically. Please visit www.digitrax.com for the
latest versions, technical updates and additional locomotive-specific installation
instructions.
I I n n s s t t a a l l l l a a t t i i o o n n I I n n s s t t r r u u c c t t i i o o n n s s - - A A t t l l a a s s G G P P 3 3 0 0 L L o o c c o o m m o o t t i i v v e e
1. Carefully remove the
locomotive's shell from
the frame. Notice the
orientation of the light
board inside so that you
can install the decoder in
the same orientation.
2. Loosen the frame screws
enough to allow the
removal of the light
board. Lift the board out
of the frame.
3. Install the decoder,
square CPU to the top,
between the frame
halves. The narrow part
of the decoder fits
between the frame with
the frame clips holding
it at the corners of the
decoder cutout. The
brass motor contacts
should contact the
matching pads on the
bottom of the decoder
and be clear of the metal
frame. Squeeze the
frame halves together to
hold the decoder in
place.
4. Tighten the frame
screws. Replace the
trucks if they have fallen
©2004 Digitrax, Inc
D D
C C
i i g g i i t t r r a a x x
o o m m m m a a n n d d
R R u u n n Y Y o o u u r r T T r r a a i i n n s s , , N N o o t t Y Y o o u u r r T T r r a a c c k k ! !
Figure 1: Remove loco shell
frame screws
Motor
contacts
Figure 3:
Place decoder in frame.
www.digitrax.com
C C
o o n n t t r r o o l l
1 Instruction sheet
Figure 2: Loosen frame
screws and remove
light board
DCC Decoder
Factory
Light board
frame clips
2