- ページ 4

メディア・コンバーター Digitrax DN163I1AのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Digitrax DN163I1A 9 ページ。

ページを印刷する

are shipped with CV01 (AD2), the two digit address, set to 03. See your Starter

Set Manual for complete programming instructions. Following is a brief

description of how to change the decoder address with a DT series throttles.

1. Place the loco on the programming track. Go into Program Mode on your

system. On DT400 press PROG. On DT300, DT100 & DT200 press

RUN/STOP & FN/F0 SIMULTANEOUSLY.

2. Choose AD2 for 2 digit addressing or AD4 for 4 digit addressing (DT300 &

DT400). (Ad for DT100 & DT200, see set system manual for 4 digit

instructions).

3. Choose the address you want to set up for the decoder.

4. Complete address programming. On DT400 press ENTER. On DT300*,

DT100 & DT200 press SEL.

*Note: CV29 must also be programmed to enable 4 digit addressing, this is

done automatically by the pressing the 'Y' key when prompted to do so on the

DT300 & DT400 throttles.

D D i i g g i i t t r r a a x x L L o o c c o o M M o o t t i i o o n n

Your locomotives look like the real thing, now you can make them run like the

real thing, too. Digitrax decoders incorporate torque compensation for smooth

as silk operation. You can also program CVs that control momentum, 3 step

and 128 step speed tables, switching speed, normal direction of travel,

scaleable speed stabilization and more to take full advantage of the Digitrax

LocoMotion System.

M M o o m m e e n n t t u u m m - - C C V V 0 0 3 3 & & C C V V 0 0 4 4

Acceleration is controlled by CV03 and deceleration by CV04. Both come

from the factory set to 000/x00. A range of 000/x00/ to 031/x1F is available for

both accel and decel. We recommend that you try CV03:003/x03 and

CV04:000/x00 as a starting point for experimenting with momentum.

S S p p e e e e d d T T a a b b l l e e s s - - H H o o w w t t h h e e L L o o c c o o R R e e s s p p o o n n d d s s t t o o t t h h e e T T h h r r o o t t t t l l e e

With Digitrax LocoMotion, there are two types of speed tables: 3 Step Tables

and High Resolution 28 Step Tables. Please see your Decoder Manual for a dis-

cussion of the 28 Step Tables. The 3 Step Tables are set up by programming 3

CVs: Start Voltage (CV02), Mid point Voltage (CV06) and Max Voltage

(CV05). These values are set at 000/x00 at the factory. All have a range of val-

ues from 000/x00 to 255/xFF. We recommend the following CV values as a

starting point for experimenting with speed tables.

D D

C C

i i g g i i t t r r a a x x

o o m m m m a a n n d d

R R u u n n Y Y o o u u r r T T r r a a i i n n s s , , N N o o t t Y Y o o u u r r T T r r a a c c k k ! !

S S y y s s t t e e m m

www.digitrax.com

C C

o o n n t t r r o o l l