- ページ 3

メディア・コンバーター Digitrax DN163K1aのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Digitrax DN163K1a 8 ページ。 N scale mobile decoder. dcc plug 'n play 1.5 amp/2.0 amp peak 6 fx3 functions, 0.5 amp

ページを印刷する

Installation Notes:

1. Do not exceed the decoder's 500mA total function output rating.

2. To use a function output with an inductive (coil) type load, see the Digitrax

Decoder Manual for more information to avoid damage to the decoder.

3. See the Digitrax Decoder Manual for full details of wiring 12-16V lamps,

1.5V lamps, and LEDs. Lamps that draw more than 80 mA when running

require a 22 ohm 1/4 watt resistor in series with the directional light func-

tion lead to protect the decoder.

Installation in Other Locomotives

The DN163K1a will fit into

other locomotives with the

same frame design but may

require some minor modifica-

tions. For instance, the Kato

C44-9W requires some modifi-

cation to the inside of the shell

of the locomotive in order for

the decoder to fit. Insert the

decoder into the frame as

shown in the previous example. Lay a small piece of carbon paper on top of the

decoder board and gently slide the shell onto the frame. Press down gently on

the top of the locomotive shell to mark where the decoder parts contact the

underside of the shell. Carefully grind these marked areas to accommodate the

LED and the components on the top of the decoder board. The approximate

locations for modification are indicated in Figure 4. You may need to glue the

stack in place after grinding is completed.

Customizing Your Decoder

Your Digitrax decoder is ready to run and will operate using address 03 with no

additional programming. For a more prototypical railroading experience, your

decoder can be customized for your specific locomotive by programming some

of the Configuration Variables, or CVs, available. See the Digitrax Decoder

Manual or the Digitrax web site for more information.

Changing the Decoder Address

The first CV most people change is the decoder address so that the loco can be

independently controlled with it's own unique address. All Digitrax decoders

are shipped with CV01 (AD2), the two digit address, set to 03. See your Starter

Set Manual for complete programming instructions. Following is a brief

description of how to change the decoder address with a DT series throttles.

450 Cemetery Street

Norcross, GA USA 30071

www.digitrax.com

Sand or grind these areas of shell

Figure 4: Modifications to Kato C44-9 shell

www.digitrax.com

770-4 4 41-7 7 992

770-4 4 41-0 0 759

[email protected]