- ページ 2
メディア・コンバーター Digitrax DS44のPDF インストレーション・インストラクションをオンラインで閲覧またはダウンロードできます。Digitrax DS44 2 ページ。 Stationary decoder for use with 4 slow motion turnout machines
ページを印刷する
Individual Address Set Up (Non Sequential Addresses)
1. Turn off track power.
2. Connect the red and black wires from the non-harness end of the DS44 to
the track.
3. Temporarily connect the white wire from the DS44 harness to the same rail
as the red wire.
4. Turn on track power.
5. Using your throttle, operate the 4 switch addresses you want to set for the
D44. The first switch address you operate sets the address of DS44 Output
A, the second sets the address of Output B, the third Output C & the fourth
sets Output D.
Example: Operate switch addresses 06, 13, 25 & 105. This will set the DS44
to control switch addresses A=06, B=13, C=25, & D=105.
6. Unhook the white wire and fold it away so it can't touch the track.
7. Consult the wiring directions for the slow motion turnout machine you are
using and wire according to the diagram in Figure 1.
Digitrax gives a one year "No Worries" Warranty against manufacturing defects and
accidental customer damage on all Digitrax products.
Visit www.digitrax.com for complete warranty details.
Made in U.S.A.
DS44
Stationary Decoder for 4 Slow Motion Turnouts
Harness End
Red
Black
White
Connect to either Red or Black
for Setup (See Instructions)
2443 Transmitter Road
Panama City, FL 32404
www.digitrax.com
850-872-9890
T
850-872-9557
F
Purple +
Black -
Gray +
Yellow -
Blue +
Orange -
Red +
Green -
Polarities shown are with
the switch in the "closed" position.
Slow Motion
Turnout
Machine
A
Slow Motion
Turnout
Machine
B
Slow Motion
Turnout
Machine
C
Slow Motion
Turnout
Machine
D