- ページ 10

メディア・コンバーター Digitrax SDH104K1AのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Digitrax SDH104K1A 12 ページ。 Plug n’ play mobile decoder with soundfx

ページを印刷する

FN04K1 is set up to control the forward and reverse lights on the locomotive

through the white lead and yellow lead using Function 0 (F0F-forward and

F0R-reverse) for directional lighting. Functions F1(Green) and F2(Violet) are

available on the FN04. To use these functions, solder a wire from the pad for

the function you wish to use to the lamp (or other device) you wish to control.

The Blue/+Common pad works the same way as the blue wire on the harness

and is provided here for convenience. The wire colors indicated are the stan-

dard industry color code (you can use any color you like). These colors are

important if you plan to use function remapping.

CAUTION: When adding function wires, be very careful that the wires you add

do not come into contact with any other pads or components on the board

where they might create a short circuit.

All four function outputs can be set up with Digitrax FX

standard on/off functions with the following operational qualifiers:

1. Forward or Reverse direction of travel, or

2. Whether F0 is on or off, or

3. Both direction of travel and whether F0 is on or off, or

4. Whether the locomotive is stopped or moving.

F F u u n n c c t t i i o o n n R R e e m m a a p p p p i i n n g g

Function remapping allows you to program the function outputs of your decoder

to be controlled by selected function keys on your throttle. Please consult the

Digitrax Decoder Manual or website for information on function remapping.

M M a a s s t t e e r r L L i i g g h h t t S S w w i i t t c c h h

Each of the four function outputs can be programmed to turn on and off with

the F0 ON/OFF key on your throttle, creating a Master Light Switch. The CV

values for creating this effect are listed in the Digitrax Decoder Manual in the

section: Setting up FX & FX

decoder. This 9 pin connector has been adopted by other companies in the DCC

industry, too.

S S o o u u n n d d F F X X D D C C O O p p e e r r a a t t i i o o n n M M o o d d e e

Digitrax SoundFX deccoders will operate on smooth DC power. The sound will

not start until approximately 5 volts is applied to the track and there will be no

"start up sound."

S S o o u u n n d d F F X X T T r r o o u u b b l l e e s s h h o o o o t t i i n n g g

If the sound does not start in the decoder

1. Make sure you have selected the locomotive on a throttle. The sound will

not run unless the locomotive is addressed in the system.

C C

T T

o o m m p p l l e e t t e e

r r a a i i n n

R R u u n n Y Y o o u u r r T T r r a a i i n n s s , , N N o o t t Y Y o o u u r r T T r r a a c c k k ! !

Effects On Function Outputs.plugs into the

www.digitrax.com

C C

o o n n t t r r o o l l

lighting effects or as