スピーカー argon audio IE20のPDF クイックスタートをオンラインで閲覧またはダウンロードできます。argon audio IE20 2 ページ。

1. Charging instruction

Please fully charge the case and ear buds before first

time use. The different numbers of LEDs on the

bottom of the charging case flashing will show the

different charge level of the case; see the chart below

for details. When the charging case is fully charged,

all four lights turn on.

Power

LED light

<25%

The first light is flashing

25-50%

The first light is on, and the second light is blinking

50-75%

The first two light is on, and the third light is blinking

75-99%

The first three lights are on, the 4th light is blinking

100%

All four lights are on

2. Power on/pairing mode

Open the charging case while the earbuds are still in

the case to initiate pairing mode. Enter Bluetooth

IE20 Quick start

settings on your device and select Argon Audio IE20

to start pairing. If the pairing was successful; you will

hear the "connected" voice prompt in the ear buds.

To enter pairing mode manually, place both left and

right earbuds into the charging case, keeping the

case cover open. Press and hold the charging case

button for 5 seconds. The four LEDs will flash

alternately in pairs before emitting constant light for

3 seconds. This indicates that the earphones have

entered Bluetooth searching and pairing mode. If

there is no connection in pairing mode for 5 minutes,

the earbuds will automatically power off.

w w w . a r g o n a u d i o . c o m