- ページ 3

モニター Argonaut R515-HTのPDF リファレンス・マニュアルをオンラインで閲覧またはダウンロードできます。Argonaut R515-HT 20 ページ。 Led marine monitor

Getting Started and Care

Your Argonaut R515/R515-HT monitor has been engineered for trouble-free use in the marine

environment. Please retain this reference guide for relevant installation, wiring, care information, and

operation adjustment (Button Controls).

Surface Mounting

The R515/R515-HT monitor has been designed for an easy, secure and sealed installation.

mount installations, please note the following steps:

1) Locate a suitable installation mounting surface. The surface should be flat and allow at least

enough room for the outside bezel face to fit (14.45" x 11.70" W x H). Note that the thickness of

the display is 1.35" so make sure there is enough clearance to mount in your desired

location. Make sure there is sufficient clearance behind the surface for cabling passage (.75"

minimum recommended). Rear surface space should also allow clearance to install mounting

screws from the rear; however, the display can be installed without using mounting screws, if

necessary.

2) Once mounting location is identified, carefully align the mounting template to the surface in the

exact location desired and secure lightly with tape. Mark the centers of the 4 top centered VESA

pattern mount holes. Mark the connector clamp bracket outline and outside edge of the

template. Once all holes are marked, surface may be drilled and cut accordingly.

3) Monitor can now be seated against the surface. In some installations, a bead of marine caulking

may be desired to help prevent any water intrusion to the mounting surface openings or the

unsealed cable clamp (R515 model).. This bead of caulking/adhesive can be placed upon the outer

edge of the back cover and may also be sufficient to secure the monitor in place without screwing

into the enclosure from behind the surface. Take care not to allow sealant to penetrate the gap

between the front bezel and rear cover as this may prevent opening the monitor if service is ever

needed. Another approach is to lay down a thin layer of weather stripping flush to the monitor

edge. This strip can be sealed at the edges with caulking. In general, after positioning/sealing is

complete, screw monitor down to surface (Note: screw type is M5 stainless steel machine

thread). Different length screws may be required depending on bulkhead thickness. In all

installations, where water contact can occur with the display, caulking sealant should be placed

around the screw and connector clamp bracket openings. Once secured to the surface, take care

not to over tighten mounting screws.

Optional Flush Mount Kit

Flush mount kit includes machined aluminum mount plate, poron shock pad, oversize polycarbonate face

plate, stainless fasteners and mounting template. Please refer to the detailed instructions provided with kit

and it is recommended to utilize a professional installer.

For surface

Page