ページを印刷する3. Performing Measurements
1. Turn the 1100T/D on by pressing the On/Off key. The display will
read
"OPEN" if no probe is attached.
MENU mode can be activated to change clock, display, and data
logging (1100D only) settings after the 1100T/D has been turned
on. Please see page 22. If no changes are necessary please
proceed to the next step.
2.
Attach a temperature probe to the input connector and use the
screw collar to secure the probe to the thermometer.
3
Touch or insert the probe into the item under test. The temperature
measured at the probe will display on the 1100T/D. Press the MENU
key to set the sub display to clock mode. The temperature will be
displayed in the main display. Please see below.
4. From the temperature / clock display the following functions can be
performed.
Data Hold - Pressing the LEFT ARROW key freezes the display and
"HOLD" will be displayed. Pressing the LEFT ARROW key again returns
the 1100D to normal operation.
14
Performing Measurements (continued)
Increased Update Rate - Pressing the RIGHT ARROW key increases the
update rate allowing quickly changing temperatures to be measured. "F"
will blink in the display while this mode is active. Please see below.
To return the update rate to normal press the RIGHT ARROW key. Note:
The update rate will automatically return to normal after 5 minutes.
5. Pressing the menu key will cycle through the clock, alarm clock,
timer, and data logging (1100D only) functions.
1100D Only - If you do not have a 1100D please skip to page 20
6. Press the MENU key repeatedly until the sub display switches to
logger display mode. Please see below
15