- ページ 16

ネットワーク・ハードウェア Cisco Physical Access 1125 ApplianceのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cisco Physical Access 1125 Appliance 42 ページ。

Preparing Your Site for Installation

Environmental

When planning your site layout and equipment locations, remember the precautions described in this

section to help avoid equipment failures and reduce the possibility of environmentally caused

shutdowns. If you are experiencing shutdowns or unusually high errors with your existing equipment,

these precautions will help you to isolate the cause of failures and prevent future problems.

Use the following precautions when planning the operating environment for your Cisco PAM:

•

Warning

This unit is intended for installation in restricted access areas. A restricted access area is where

access can only be gained by service personnel through the use of a special tool, lock and key, or

other means of security, and is controlled by the authority responsible for the location.

For optimal installation, choose a site:

•

Never defeat the ground conductor or operate the equipment in the absence of a suitably installed

Warning

ground conductor. Contact the appropriate electrical inspection authority or an electrician if you are

uncertain that suitable grounding is available.

Follow these guidelines to create a safe operating environment:

•

Cisco Physical Access 1125 Appliance User Guide

2-2

Always follow the ESD-prevention procedures described in

Discharge, page

-vii, to avoid damage to equipment. Damage from static discharge can cause

immediate or intermittent equipment failure.

Ensure that the chassis cover is secure. The chassis allows cooling air to flow effectively within it.

An open chassis allows air leaks, which could interrupt and redirect the flow of cooling air from

internal components.

Electrical equipment generates heat. Ambient air temperature might not be adequate to cool

equipment to acceptable operating temperatures without adequate circulation. Ensure that the room

in which you operate has adequate air circulation.

With a dry, clean, well-ventilated and air-conditioned area.

That maintains an ambient temperature of 10° to 35°C (50° to 95°F).

Keep tools and chassis components off the floor and away from foot traffic.

Clear the area of possible hazards, such as moist floors, ungrounded power extension cables, and

missing safety grounds.

Keep the area around the chassis free from dust and foreign conductive material (such as metal

flakes from nearby construction activity).

Chapter 2

Preparing to Rack Mount the 1125 Appliance

Protecting Against Electrostatic

OL-20929-01