- ページ 33

ネットワーク・ハードウェア Cisco Physical Access 1125 ApplianceのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cisco Physical Access 1125 Appliance 42 ページ。

ページを印刷する
Cisco Physical Access 1125 Appliance ユーザーマニュアル
Chapter 3
Rack Mounting the Cisco PAM 1125 Appliance
Figure 3-13
The following items are shown in
1

Setting the Multi-Pin Adapters for Rack Type

Note
•
•
The Multi-pin Adapters allow the slide rails to be used in racks that have square mounting holes or round
mounting holes.
To set the adapters for the rack type, perform the following procedure:
On each slide rail, reverse the Multi-Pin Adapter position to match the rack mounting hole type if
Step 1
necessary. Remove the Multi-Pin Adapter by rotating the Swivel Lock up, pressing the mounting pins
together, and then pulling the adapter from the Multi-Pin Bracket.
Step 2
Install the Multi-Pin Adapter by pressing the pins together while inserting the adapter into the bracket.
Multi-Pin Adapter must be fully locked in the bracket. Make certain both mounting pins on the Multi-Pin
Adapter are fully engaged in the Multi-Pin Bracket; then lock the Multi-Pin Adapter in place using the
Swivel Lock.
Repeat the above steps for both ends of each slide rail.
Step 3
To lock the adapters in place, follow these steps:
Step 4
a.
b.
c.
OL-20929-01
Release Levers on the Slide Rail Hardware
1
Slide release lever
The 10-32 threaded holes in the fixed portion of the Multi-Pin Adapter are for securing during
shipping (if desired) and for the attachment of front panel blanks (if desired)
The slide rails are shipped with the Multi-Pin Adapters set for square holes. If your rack has square
mounting holes, skip this section.
Rotate Swivel Lock to "up" position (see the left-hand illustration in
together and insert rack mating end of Multi-Pin Adapter through corresponding holes in bracket.
(Insert into bracket with slotted pin in "up" position as shown.)
When Multi-Pin Adapter is fully seated in bracket, close the swivel lock (right-hand illustration in
Figure
3-14).
If you have the adapter seated properly, you should be able to easily rotate the Swivel Lock to the
fully locked (closed) position.
2
Figure
3-13:
2
Component release lever
Cisco Physical Access 1125 Appliance User Guide
Rack Mounting the Cisco PAM 1125 Appliance
Figure
3-14). Press pins
3-15