- ページ 2

オール・イン・ワン・プリンター Epson XP-630のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Epson XP-630 4 ページ。 Small-in-one printer
Epson XP-630 にも: クイックマニュアル (17 ページ), ここからスタート (4 ページ)

Epson XP-630 クイック・スタート・マニュアル
2
Gently shake the Black (BK) ink cartridge. Do not shake
Photo Black (PBK) or other ink cartridges.
3
Unpack the ink cartridges.
Caution:
Do not touch the areas shown below. Doing so may
prevent normal operation and printing.
4
Remove the cap from each ink cartridge. Store the caps in
the included plastic bag.
Note:
Save the caps and use them to recap the ink cartridges
after removing them for storage or disposal.
5
Insert the cartridges at an angle in the holder for each
color. Press each cartridge down until it clicks.
6
Lower the scanner unit.
7
The printer starts charging the ink. Ink charging takes
approximately 7 minutes. When you see a completion
message on the printer's LCD screen, charging is
complete.
Caution:
Don't turn off the printer or raise the scanner unit while
the printer is charging or you'll waste ink.
Note:
• The printer is designed for use with Epson
third-party cartridges or ink.
• The cartridges included with the printer are designed for
printer set up and not for resale. After some ink is used for
charging, the rest is available for printing.
cartridges only, not
®
4

Load paper

See the online User's Guide for instructions on loading paper in
the cassette 1 and rear paper slot, available paper types, sizes,
loading capacity, and loading CD/DVD/Blu-ray
XP-830).
XP-630/XP-830
Output tray
Cassette 1
You can load the following paper sizes:
• Cassette 1: 3.5 × 5-, 4 × 6-, or 5 × 7-inch photo paper
• Cassette 2: Letter-size, A4-, legal-size, or 8 × 10-inch paper
See the instructions below for loading paper.
• Rear paper feed slot: One sheet at a time (XP-830)
XP-530
Output tray
You can load the following paper sizes: 3.5 × 5-, 5 × 7-, 8 × 10-
inch, letter-size, A4-, or legal-size.
1
Lower the front cover (if it's not open already) and pull on
the front cover to pull out the paper cassette.
2
Slide the side edge guides outward and set the front edge
guide to the paper size you are using.
3
Insert the paper with the glossy or printable side
facedown.
Note:
Make sure the paper is loaded against the front edge
guide and not sticking out from the end of the cassette.
discs (XP-630/
Cassette 2/front cover
Cassette/front cover