- ページ 34

ネットワーク・ハードウェア Cisco SCE8000 GBEのPDF 取り外しと交換の手順をオンラインで閲覧またはダウンロードできます。Cisco SCE8000 GBE 36 ページ。 10gbe platform
Cisco SCE8000 GBE にも：クイック・スタート・マニュアル (25 ページ), 設定マニュアル (18 ページ), インストール (21 ページ)

ページを印刷する

Removing and Replacing the Optical Bypass Module

•

Removing the Optical Bypass Module

Disconnect all cables.

Step 1

Loosen the two captive screws on the module.

Step 2

Pull the module out of the slot. Place your other hand under the module to support the weight of the

Step 3

module. Do not touch the module circuitry.

Place the module on antistatic foam, or immediately reinstall it in another slot.

Step 4

If the slot is to remain empty, install a module filler plate to keep dust out of the chassis and to maintain

Step 5

proper airflow through the chassis.

Installing the Optical Bypass Module

Step 1

Remove the module filler plate by loosening the two screws.

Step 2

Insert the module into the opening in the panel. There are no guide rails. Do not touch the module

circuitry.

Tighten the two captive screws on the module.

Step 3

Step 4

Connect the cables as described in the

Optical Bypass Module" section on page

Replacing the Optical Bypass Module Without Disrupting Traffic on the Link

You can replace a malfunctioning Cisco SCE 8000 platform without disrupting traffic on the link by

removing the optical bypass modules while still connected to the network and installing them into the

new Cisco SCE 8000.

Step 1

Install the new Cisco SCE 8000 platform in the rack. Power up the platform and perform necessary initial

configuration.

Step 2

Disconnect the cables connecting the optical bypass module to the old Cisco SCE 8000 platform. Do not

disconnect the cables connecting the optical bypass to the subscriber side or network side network

elements.

Cisco SCE8000 10GBE Installation and Configuration Guide

9-34

Removing the Optical Bypass Module, page 9-34

Installing the Optical Bypass Module, page 9-34

Replacing the Optical Bypass Module Without Disrupting Traffic on the Link, page 9-34

Chapter 9 Removal and Replacement Procedures

"Cabling the 10 GBE Line Interface Ports: Using the External

6-14.

OL-26784-02