- ページ 5

ネットワーク・ハードウェア Cisco Secure Firewall Management Center 2700のPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco Secure Firewall Management Center 2700 22 ページ。

About the Secure Firewall Management Center 1700, 2700, and 4700

• Connect a local computer to the management center serial port as described in the procedure below.

AC power supplies have internal grounding so no additional chassis grounding is required when the supported

AC power cords are used. For more information about supported power cords, see the

Management Center 1700, 2700 and 4700 Hardware Installation Guide

After rack-mounting the chassis, follow these steps to connect the cables.

Figure 1: Cable the Appliance to a Management Network

Before you begin

Important

Read the

chassis.

Rack-mount the appliance as described in the Cisco Secure Firewall Management Center 1700, 2700, and

4700 Hardware Installation Guide.

If you plan to cable the appliance using the console port and a local computer, redirect the console output to

the console port. For more information, see

and

Redirect the Console Output Using the CLI, on page

Procedure

Step 1

Cable the following to your management network:

• Management 1/1 interface

• Management computer

Step 2

Connect the management computer to the console port using an RJ-45 to DB-9 console cable. Use the console

port to access the CLI for initial setup.

Step 3

Use a terminal emulation software (such as HyperTerminal or XModem) on the local computer to interact

with the management center. Set the terminal emulator for 9600 baud, 8 data bits, no parity, 1 stop bit, and

no flow control.

Regulatory and Compliance Safety Information

Cisco Secure Firewall Management Center 1700, 2700, and 4700 Getting Started Guide

document before installing the management center

Redirect the Console Output Using the Web Interface, on page

11.

Cable the Management Center

Cisco Secure Firewall