- ページ 27

サーバー Cisco 2500 SeriesのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco 2500 Series 47 ページ。 Wireless controller
Cisco 2500 Series にも：設置マニュアル (12 ページ), 設定マニュアル (19 ページ), 配備マニュアル (23 ページ), 設定マニュアル (50 ページ)

ページを印刷する

Table 3

Wizard Setting

Enter Country Code List

Enable 802.11b Network

Enable 802.11a Network

Enable 802.11g Network

Enable Auto-RF

Configure a NTP server now?

Enter the NTP server IP address

Enter a polling interval between 3600 and 604800

secs

Configuration correct?

Logging into the Controller

To log into the 2504 controller, follow these steps:

Step 1

Enter a valid username and password to log into the controller CLI.

Step 2

The CLI displays the root level system prompt:

Startup Wizard Information (continued)

Note

The administrative username and password you created in the startup wizard are case

sensitive.

#(system prompt)>

The system prompt can be any alphanumeric string up to 31 characters. You can change it by

entering the config prompt command. For example, to change the system prompt to

CISCO2504, enter config prompt "CISCO2504" and press Enter. Make sure you enter the new

prompt using double quotation marks.

Action

Enter the two letter country code. The default country code is

the United States (US). Enter 'help' to see a list of countries.

Choose YES to enable or no to disable the 802.11b radio

network. The default is YES.

Choose YES to enable or no to disable the 802.11a radio

network. The default is YES.

Choose YES to enable or no disable the 802.11g radio

network. The default is YES.

Choose YES to enable or no to disable radio resource

management. The default is YES.

Enter YES to configure an NTP server. The values are YES or

no. The default value is YES.

Enter the NTP server IP address.

This prompt only displays if YES was entered in the

Note

"Configure a NTP Server Now?" prompt.

Enter the polling interval between 3600 and 604800 seconds.

Note

This prompt only displays if YES was entered in the

"Configure a NTP Server Now?" prompt.

Enter yes if the configuration entered is correct. Values are yes

and no. If yes is entered. the controller saves your

configuration, reboots, and prompts you to log in.

Cisco 2500 Series Wireless Controller Getting Started Guide

Logging into the Controller