- ページ 29

サーバー Cisco 3500 SeriesのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 3500 Series 36 ページ。

Install the Cisco SNS 3515 and Cisco SNS 3595 Hardware Appliances
c) Continue with
Remote Connection Procedure
Step 1
Attach a power cord to each power supply unit in your server, and then attach each power cord to a grounded AC power
outlet. See
Power Specifications, on page 14
Wait for approximately two minutes to let the server boot in standby power during the first bootup.
You can verify system power status by looking at the system Power Status LED on the front panel (see
on Cisco SNS 3515 and 3595 Appliances, on page
Step 2
Plug your management Ethernet cable into the dedicated management port on the rear panel (see
3595 Appliance Back Panel View, on page
Step 3
Allow your preconfigured DHCP server to assign an IP address to the server node.
Step 4
Use the assigned IP address to access and log in to the Cisco IMC for the server node. Consult with your DHCP server
administrator to determine the IP address.
Note
The default user name for the server is admin. The default password is password.
Step 5
From the Cisco IMC Server Summary page, click Launch KVM Console. A separate KVM console window opens.
Step 6
From the Cisco IMC Summary page, click Power Cycle Server. The system reboots.
Step 7
Select the KVM console window.
Note
The KVM console window must be the active window for the following keyboard actions to work.
Step 8
When prompted, press F8 to enter the Cisco IMC Configuration Utility. This utility opens in the KVM console window.
This utility has two windows that you can switch between by pressing F1 or F2.
Step 9
Continue with
Setup CIMC Configuration Utility, on page

Cisco Integrated Management Controller

You can monitor the server inventory, health, and system event logs by using the built-in Cisco Integrated
Management Controller (CIMC) GUI or CLI interfaces. See the user documentation for your firmware release
at the following URL:
http://www .cisco.com/c/en/us/support/servers-unified-computing/ucs-c-series-integrated-management-controller/products-installation-and-configuration-guides-list.html
Note
You must use the versions of CIMC firmware from the ISE downloads, which are qualified versions for use
with the SNS appliances. Versions of CIMC for UCS are not compatible. Newer versions of CIMC are
developed for SNS appliances after they are developed for UCS.
Check the download directory for release notes or upgrade instructions.
Setup CIMC Configuration Utility, on page
for power specifications.
5).
Cisco Secure Network Server 3500 Series Appliance Hardware Installation Guide
26.
1). The system is in standby power mode when the LED is amber.
26.
Remote Connection Procedure
LED Indicators
Cisco SNS 3515 or SNS
25