- ページ 5

サーバー Cisco 700 seriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 700 series 8 ページ。 Using profiles
Cisco 700 series にも：概要 (19 ページ), スタートマニュアル (27 ページ), ユーザーマニュアル (9 ページ), 管理マニュアル (36 ページ)

ページを印刷する

Connect the other end of the ISDN S/T cable to the ISDN wall socket.

Step 2

If necessary, use the enclosed RJ-45-to-RJ-11 adapter to connect to an RJ-11 ISDN wall

Note

jack.

Connect the Power and Turn On the Router

This section describes the procedure for supplying power to the router.

Step 1

Connect the power supply cable to the round, black power connector on the rear panel of the router,

connect the power supply cord to the power supply, and connect the power supply cord to an electrical

outlet.

Step 2

Turn on the router by using the on/off switch on the rear panel. The green RDY LED (and the NT1

LED on the Cisco 772 and Cisco 776) on the front panel of your router turns on. Your router is now

ready to be set up.

If the green RDY LED is not on, refer to the "Troubleshooting Cisco 700 Series Routers" chapter in

the Cisco 700 Series Router Installation Guide.

78-10157-01

CO NF IG

ET HE RN

CI SC O 77

IS DN S/

?? ?

BR I

+5V ---1 .5A

+/-5 %

-30 V-- - 0.2

A +/-2 5%