- ページ 2

サーバー Cisco 700 seriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cisco 700 series 9 ページ。 Using profiles
Cisco 700 series にも：クイック・スタート・マニュアル (8 ページ), 概要 (19 ページ), スタートマニュアル (27 ページ), 管理マニュアル (36 ページ)

In addition to user-deﬁned proﬁles, there are three permanent proﬁles, Internal, LAN, and

Standard. The Internal proﬁle stores parameters used to communicate between the LAN

and WAN ports on the Cisco 700 series router. The LAN proﬁle stores parameters that

conﬁgure the LAN port on the router. The Standard proﬁle is the default proﬁle. If

authentication is not required and the destination device you are connecting to does not

have a user-deﬁned proﬁle, the router uses the Standard proﬁle.

Proﬁles and Connections

Proﬁles are either active or inactive. An active proﬁle creates a virtual connection to the

remote device associated with the proﬁle. A virtual connection is a connection without

physical channels. After creating a virtual connection, an on-demand call can be made to

the associated remote device to establish a physical connection.

A physical connection is a dynamically created pipeline of packets from the Cisco 700

series router to a switch on the WAN. All connections are associated with the proﬁle that

deﬁnes the conﬁguration of the connection.

Virtual and physical connections behave similarly; the difference is that physical

connections forward packets to the WAN. Virtual connections monitor packet trafﬁc on the

LAN until a demand ﬁlter "sees" that a packet is destined for the WAN and initiates a call

to the switch, opening the physical connection. Once the call is established, the virtual

connection becomes an active physical connection, and the packets move through the

pipeline.

System and Proﬁle Parameters

The system is composed of both system mode parameters, user-deﬁned proﬁles, and

permanent proﬁles. System mode parameters can be changed only in system mode. The

prompt indicates you are in system mode by displaying nothing or the router name. An

example of the prompt is shown below:

Router_name>

If you are in proﬁle mode, the proﬁle name appears on the prompt, separated from the

system name by a colon (:). An example of the prompt is shown below:

Router_name:Profile>

2-2

Cisco700 Series Router Configuration Guide