- ページ 12

サーバー Cisco Firepower 2130のPDF インストレーション＆メンテナンスをオンラインで閲覧またはダウンロードできます。Cisco Firepower 2130 26 ページ。 Rack-mount and ground the chassis
Cisco Firepower 2130 にも：マニュアル (12 ページ), 配備マニュアル (8 ページ), はじめに (42 ページ)

ページを印刷する

Connect the DC Power Supply Module

Warning

Before you begin

• The color coding of the DC input power supply leads depends on the color coding of the DC power

• Make sure that the chassis ground is connected on the chassis before you begin installing the DC power

Step 1

Verify that the power is off to the DC circuit on the power supply module that you are installing.

Step 2

While supporting the power supply module with one hand, insert the power supply module into the power supply bay

and gently push it in. See the figure above for the location of the handle.

Step 3

Use a wire-stripping tool to strip each of the 2 wires coming from the DC input power source. Strip the wires to

approximately 0.39 inch (10 mm) + 0.02 inch (0.5 mm). We recommend you use 14 AWG insulated wire.

Installation, Maintenance, and Upgrade

Statement 1073 No User-Serviceable Parts

There are no serviceable parts inside. To avoid risk of electric shock, do not open.

Statement 1046 Installing or Replacing the Unit

To reduce risk of electric shock, when installing or replacing the unit, the ground connection must always

be made first and disconnected last.

Statement 1089 Instructed and Skilled Person Definitions

An instructed person is someone who has been instructed and trained by a skilled person and takes the

necessary precautions when working with equipment.

A skilled person or qualified personnel is someone who has training or experience in the equipment

technology and understands potential hazards when working with equipment.

Statement 1090 Installation by Skilled Person

Only a skilled person should be allowed to install, replace, or service this equipment. See statement 1089

for the definition of a skilled person.

Statement 1091 Installation by an Instructed Person

Only an instructed person or skilled person should be allowed to install, replace, or service this equipment.

See statement 1089 for the definition of an instructed or skilled person.

source at your site. Make sure that the lead color coding you choose for the DC input power supply

matches the lead color coding used at the DC power source and verify that the power source is connected

to the negative (–) terminal and to the positive (+) terminal on the power supply.

supply. See

Ground the Chassis

for the procedure.

Installation, Maintenance, and Upgrade