- ページ 36
サーバー Cisco Firepower Management Center 3500のPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco Firepower Management Center 3500 42 ページ。 Firepower management center
ページを印刷する
—
For Versions 6.5+, see
If you deleted license and network settings, you must configure the appliance as if it were new, beginning with
configuring it to communicate on your management network. For more information:
—
For Versions 5.4.x - 6.4.x, see
—
For Versions 6.5+, see
If you deregistered the Firepower Management Center from the Cisco Smart Software Manager, register the
appliance to the Cisco Smart Software Manager. Choose System > Licenses > Smart Licenses and click the
register icon.
After you complete the initial setup process:
If you want to use a serial or SOL/LOM connection to access your appliance's console, you should redirect
console output; see
If LOM was reset during the restore and you want to use LOM, you must re-enable the feature as well as enable
at least one LOM user; see
Setting Up Lights-Out Management
If you need to restore a Firepower device to factory defaults and do not have physical access to the appliance,
you can use Lights-Out Management (LOM) to perform the restore process. Note that you can use Lights-Out
Management on the default (
The LOM feature allows you to perform a limited set of actions on a Firepower device, using a Serial over LAN
(SOL) connection. With LOM, you use a command line interface on an out-of-band management connection to
perform tasks such as viewing the chassis serial number, or monitoring conditions such as fan speed and
temperature.
Caution:
The Firepower Management Center 2000 and 4000 introduced Cisco's Unified Computing System
(UCS) platform into the Firepower System. These models do not support Cisco functionality that uses tools
on the baseboard management controller (BMC), such as the UCS Manager or the Cisco Integrated
Management Controller (CIMC), to make any configuration changes or firmware updates.
The syntax of LOM commands depends on the utility you are using, but LOM commands generally contain the
elements listed in the following table.
.
Table 5
LOM Command Syntax
IPMItool
(Linux/Mac)
ipmitool
n/a
-I lanplus
-H IP_address
Cisco Firepower Management Center Getting Started Guide
Firepower Management Center Initial Configuration Wizard, page
Installation and Initial Setup for Versions 5.4 - 6.4.x, page
Installation and Initial Setup for Versions 6.5+, page
Redirecting Console Output, page
Enabling LOM and LOM Users, page
) management interface only.
eth0
ipmiutil (Windows)
Description
ipmiutil
Invokes the IPMI utility.
-V4
For ipmiutil only, enables admin privileges for the
LOM session.
-J3
Enables encryption for the LOM session.
-N IP_address
Specifies the IP address of the management
interface on the appliance.
Restoring a Firepower Management Center to Factory Defaults
19.
37.
7.
10.
4.
36