- ページ 40
サーバー Cisco Firepower Management Center 3500のPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco Firepower Management Center 3500 42 ページ。 Firepower management center
ページを印刷する
Installing the System
Use the installation procedures described in
Install the Appliance, page
1500, 2000, 3500, and 4000 Hardware Installation Guide.
When preconfiguring the system, keep the following in mind:
Add licenses for managed devices during the initial setup. If you do not add licenses at that time, any devices
you register during initial setup are added to the Management Center as unlicensed; you must license each of
them individually after the initial setup process is over. See
Preparing the Appliance for Shipment
To prepare the appliance for shipment, you must safely power down and repackage the appliance:
To safely power down the appliance, see the Cisco Firepower Management Center 1000, 2500, and 4500
Hardware Installation Guide.
To ensure that your appliance is safely prepared for shipping, see
Deleting a License from a Management Center
Use the following procedure if you need to delete a license for any reason. Keep in mind that, because Cisco
generates licenses based on each Management Center's unique license key, you cannot delete a license from one
Management Center and reuse it on a different Management Center. For more information, see See Licensing the
Firepower System in the Firepower Management Center Configuration Guide.
To delete a license:
1.
Select
Systems > Licenses
2.
Next to the license you want to delete, click the delete icon (
Deleting a license removes the licensed capability from all devices using that license. For example, if your
Protection license is valid and enabled for 100 managed devices, deleting the license removes protection
capabilities from all 100 devices.
3.
Confirm that you want to delete the license.
The license is deleted
Shipping Considerations
To prepare the appliance for shipment to the target location, you must safely power down and repackage the
appliance. Keep in mind the following considerations:
Use the original packaging to repack the appliance.
Include all reference material and power cords with the appliance.
Provide all setting and configuration information to the target location, including the new password and the
detection mode.
Troubleshooting the Appliance Preconfiguration
If your appliance is correctly preconfigured for target deployment, you can install and deploy the appliance without
further configuration.
Cisco Firepower Management Center Getting Started Guide
Installation and Initial Setup for Versions 5.4 - 6.4.x, page 10
11. For additional information, see the Cisco Firepower Management Center 750,
.
Preconfiguring Firepower Management Centers
License Settings, page
15.
Shipping Considerations, page
).
and
40.
40