EPSON Stylus CX6400
3. When done, press the OK button.
When your ink starts getting low, make sure you have
replacement cartridges available. You cannot print if an ink
cartridge is empty.
Removing and Installing Ink Cartridges
Follow these steps to replace a cartridge:
1. Make sure the CX6400 is turned on and not printing.
2. If an ink cartridge is empty:
Check the LCD screen to see which cartridge is empty, then
press the x Color button.
If an ink cartridge is low:
Press the Setup button to enter Setup Mode, then press
the top left button next to the LCD screen until Replace
ink is displayed. Finally, press the x Color button.
3. Lift up the scanner section.
4. Wait for the ink cartridge holder to move to the
replacement position, then open its cover.
EPSON Stylus CX6400
12 -
5. Identify the cartridge you need to replace. Press in the tab at
the back of the cartridge to release it, then lift the cartridge
straight out. Dispose of it carefully.
Note:
The illustration above shows the black cartridge being removed.
Only remove the cartridge(s) you need to replace.
6. Before unwrapping the new cartridge, shake it gently four
or five times. Then remove it from its wrapper.
Caution:
Don't touch the green circuit board on the front of the cartridge;
you may inhibit normal operation and printing.
7. Lower the new cartridge into its holder, then press down
firmly until it clicks into place.
If you need to replace other ink cartridges, repeat steps 5
through 7 before continuing with step 8.
8. Close the cartridge cover.
Caution:
If you find it difficult to close the cover, make sure all the
cartridges are firmly seated. Press down on each newly installed
cartridge until you hear it click into place. Do not attempt to force
the cover closed.
9. Carefully lower the scanner section and press it down until
it clicks into place.
10/03
ページを印刷する