ページを印刷する
L2TP Network Server
Table 1: Required Information for Source Context Configuration
Required Information
Source context name
PDN Interface Configuration
PDN interface name
IP address and subnet
Physical port number
Physical port description
Gateway IP address
LNS service Configuration
Source Context Configuration
Description
This is an identification string between 1 and 79
characters (alpha and/or numeric) by which the source
context will be recognized by the system.
This is an identification string between 1 and 79
characters (alpha and/or numeric) by which the
interface will be recognized by the system.
Multiple names are needed if multiple interfaces will
be configured.
These PDN interfaces facilitates the L2TP
tunnels/sessions from the LAC and are configured in
the source context.
These will be assigned to the PDN interface.
Multiple addresses and/or subnets are needed if
multiple interfaces will be configured.
This specifies the physical port to which the interface
will be bound. Ports are identified by the chassis slot
number where the line card resides in, followed by
the number of the physical connector on the line card.
For example, port 17/1 identifies connector number
1 on the card in slot 17.
A single physical port can facilitate multiple
interfaces.
This is an identification string between 1 and 79
characters (alpha and/or numeric) by which the
physical port will be recognized by the system.
Multiple descriptions are needed if multiple ports will
be used.
Physical ports are configured within the source context
and are used to bind logical PDN interfaces.
Used when configuring static routes from the PDN
interface(s) to a specific network.
L2TP Network Server
3