Paper Feeding Problems
■
If paper doesn't feed, remove it from the sheet feeder. Fan the paper, load it
against the right side, behind the feeder guard, and slide the left edge guide
against the paper (but not too tightly).
■
If paper jams, follow these steps:
1. Press the P
2. Lift up the scanner and remove any paper that's inside, including any
small pieces that may have torn off.
Caution:
Clear paper jams by pulling the paper out towards the front of the CX6600.
Never pull the paper out in the direction of the sheet feeder.
3. Turn the CX6600 back on and reload the paper. Make sure the edges are
not creased or folded.
Copy Quality Problems
If you have any problems with the quality of your copies, try these solutions:
■
Make sure the document is placed flat against the document table glass. If
only part of the image is blurred, your document may be wrinkled or warped.
■
Make sure the CX6600 is not tilted or placed on an uneven surface.
■
Clean the print head; see page 31 for instructions.
■
If a dotted line appears in the image, clean the scanner glass with a soft, dry,
lint-free cloth (paper towels are not recommended). If the glass is still not
clean, use a small amount of glass cleaner on a soft cloth. Make sure you wipe
off any remaining liquid. Don't spray glass cleaner directly on the glass.
■
Make sure your paper isn't damp, curled, or loaded face down (the printable
side should be face up). Load new paper face up. Use Epson papers for proper
saturation and absorption of genuine Epson inks.
■
Use a support sheet with special paper or load your paper one sheet at a time.
■
If you notice jagged vertical lines, you may need to align the print head. See
your on-screen CX6600 Reference Guide for instructions.
■
The ink cartridges may be old or low on ink; see page 33 for instructions on
replacing an ink cartridge.
38
Solving Problems
button to turn off the CX6600.
On
ページを印刷する