- ページ 7

サーバー Cisco Nexus 7000 SeriesのPDF 交換取扱説明書をオンラインで閲覧またはダウンロードできます。Cisco Nexus 7000 Series 14 ページ。 Switch chassis
Cisco Nexus 7000 Series にも：リファレンス・マニュアル (2 ページ), 取付説明書 (39 ページ), 参考 (34 ページ), インストレーション・マニュアル (18 ページ), 設定 (8 ページ), 設定マニュアル (28 ページ), クイック・スタート・マニュアル (10 ページ), クイック・スタート・マニュアル (29 ページ), 交換取扱説明書 (21 ページ), 設置マニュアル (16 ページ), トラブルシューティングマニュアル (10 ページ)

Replacing the Panels

Cisco 7000 Air Filter and Chassis Blower Replacement Instructions 7

Step 3:

On the top front panel, use a screwdriver to loosen the two captive screws at

the bottom edge of the panel frame.

Step 4:

Place one hand against the top front center of the panel to brace it (see

Figure 5a). The top of the panel acts as a pivot point when you pull the

bottom out and away from the chassis.

Figure 5

Removing the Top Front Panel

Step 5:

With your other hand, grasp the front of the panel by inserting your ﬁngers

into the opening on the underside of the bezel (see Figure 5a).

Step 6:

While pushing slightly against the top of the panel to constrain it, pivot the

bottom edge of the frame outward about two inches (see Figure 5a). Because

of the tightly compressed EMI shielding, you will have to use signiﬁcant force

to pull the bottom of the panel outward. However, be careful that you do not

pull the panel more than two inches away from the chassis, or you can damage

the inner bezel or LED board.

Step 7:

When the bottom of the frame clears the chassis opening, keep your hands in

the same positions and pull the panel downward and off the chassis (see

Figure 5b).

To replace the front panels, perform the following steps:

Step 1:

Grasp the sides of the top panel with both hands (see Figure 6a).