- ページ 8

サーバー Cisco Nexus 7000 SeriesのPDF 設置マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Nexus 7000 Series 16 ページ。 Switch chassis
Cisco Nexus 7000 Series にも：リファレンス・マニュアル (2 ページ), 取付説明書 (39 ページ), 参考 (34 ページ), インストレーション・マニュアル (18 ページ), 設定 (8 ページ), 設定マニュアル (28 ページ), クイック・スタート・マニュアル (10 ページ), クイック・スタート・マニュアル (29 ページ), 交換取扱説明書 (14 ページ), 交換取扱説明書 (21 ページ), トラブルシューティングマニュアル (10 ページ)

Installing the Chassis on a Four-Post Rack or Cabinet

• To remove a power supply, follow these steps:

1. Slide the handle in the middle of the ejector lever towards the end of the lever and rotate the lever away from

the power supply.

2. Pull the power supply a couple of inches (about 5 cm) out of the chassis.

3. Place one hand under the power supply to support its weight and pull the power supply out of the chassis.

4. Place the power supply on an antistatic surface.

• To remove a fan tray, follow these steps:

1. Unscrew the two captive screws on the front of the fan tray.

2. Hold both handles on the fan tray with both of your hands and pull the fan tray out of the chassis.

3. Place the fan tray on an antistatic surface.

Step 2

Prepare chassis by installing the front and side brackets.

Step 3

Align the rear of the chassis to the front of the rack or cabinet.

Figure 3: Moving a Chassis onto a Rack or Cabinet

2 front mount brackets with eight M4 screws..

2 side C-shape brackets with four M3 screws.

Step 4

Push the chassis all the way onto the rack so that the vertical mounting brackets on the chassis come in contact with the

vertical mounting rails on the rack.

Installing the Switch Chassis