- ページ 16
サーバー Cisco S695FのPDF ハードウェア・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco S695F 50 ページ。 Web security appliance
Cisco S695F にも： スタートマニュアル (18 ページ), マニュアル (24 ページ)
ページを印刷する
Rear Panel
Rear Panel
The following figure shows the rear panel of the WSA S195 and S395. See
a description of the LEDs.
Figure 10: S195 and S395 Rear Panel
1
3
5
7
9
11
13
15
Cisco Web Security Appliance S195, S395, S695, and S695F Hardware Installation Guide
12
USB 3.0 Type A (USB 1)
Management interface (M1)
Restricted to management use only
RPC port (RPC)
Use for remote power cycling.
Unit identification button
770-W AC power supply (PSU 2)
The S195 ships with one power supply, but you
can order a second one for redundancy. The S395
ships with two power supplies.
Proxy port 1 (P1)
Connects to the network for both incoming and
outgoing traffic.
Traffic monitor port 1 (T1)
Use for Duplex Ethernet tap; one cable for all
incoming and outgoing traffic.
Riser handle
Not supported
Rear Panel LEDs, on page 15
2
USB 3.0 Type A (USB 2)
4
Management interface (M2)
Not in use
6
Serial console port (Console)
RJ-45 connector that directly connects a
management computer to the appliance.
8
770-W AC power supply (PSU 1)
10
Threaded holes for dual-hole grounding lug
Use is optional. The supported AC power supplies
have internal grounding, so no additional chassis
grounding is required.
Proxy port 2 (P2)
12
When P1 and P2 are both enabled, you must
connect P1 to the internal network and P2 to the
internet.
You can connect P1 and P2 to an L4
Note
switch, WCCP router, or network
switch.
14
Traffic monitor port 2 (T2)
Use for Simplex Ethernet tap; one cable connected
to T1 for all packets going to the internet. and one
cable connected to T2 for all packets coming from
the internet.
—
Overview
for