- ページ 12

サーバー Cisco SCE8000 GBEのPDF インストールをオンラインで閲覧またはダウンロードできます。Cisco SCE8000 GBE 21 ページ。 10gbe platform
Cisco SCE8000 GBE にも： クイック・スタート・マニュアル (25 ページ), 設定マニュアル (18 ページ), 取り外しと交換の手順 (36 ページ)

ページを印刷する
Cisco SCE8000 GBE インストール
DC-Powered Systems
Table 4-5
Table 4-5
Specification
PWR-2700-DC/4 minimum
capability
DC-input power consumption
DC-input voltage rating
DC-input current rating
DC-input cable
DC-input circuit breaker
The DC supplies each have the provision for a dual connection to the power source in order to permit
Note
high-power operation without exceeding current ratings. For the Cisco SCE8000, it is not necessary to
connect both of these inputs to DC power sources; it is sufficient to connect only the '1' connections.
Cisco SCE8000 10GBE Installation and Configuration Guide
4-12
lists the Cisco SCE 8000 DC power specifications.
Cisco SCE 8000 DC Power Supply Specification
Acceptable Range
1350 W output (1750 W input)
•
•
-48 VDC to -40 VDC
(operating range: -40.5 VDC to -72 VDC)
45 A maximum at 120 VAC
Accepts 2-14 AWG copper conductors. Actual size of the wire
needed is determined by the installer or local electrician.
Terminal block material rated at 150°C (302°F).
For multiple DC input power supplies, each DC input must be
protected by a dedicated two-pole circuit breaker or a fuse.
The circuit breaker or the fuse must be sized according to the power
supply input power rating and any local or national electrical code
requirements.
Single SCE8000-SCM-E module:
1000 W (21 A @ 48 VDC, 17 A @ 60 VDC)
Dual SCE8000-SCM-E modules:
1430 W (30 A @ 48 VDC, 24 A @ 60 VDC)
Chapter 4 Installing the Cisco SCE8000 Chassis
OL-21054-04