- ページ 3

サーバー Cisco SNS-3415 seriesのPDF 設置マニュアルをオンラインで閲覧またはダウンロードできます。Cisco SNS-3415 series 19 ページ。 Sns-3400 series
Cisco SNS-3415 series にも：インストレーション・マニュアル (36 ページ), トラブルシューティングマニュアル (8 ページ)

Chapter 8

Installing the Cisco SNS 3415 and Cisco SNS 3495 Hardware Appliances

Install the slide rails onto the rack:

Step 2

Position a slide-rail assembly inside the two left-side rack posts (see

Use the "FRONT" and "REAR" markings on the slide-rail assembly to orient the assembly correctly

with the front and rear rack posts.

Position the front mounting pegs so that they enter the desired front rack-post holes from the front.

Note

Expand the length-adjustment bracket until the rear mounting pegs protrude through the desired

holes in the rear rack post.

Use your finger to hold the rear securing latch open when you insert the rear mounting pegs to their

holes. When you release the latch, it wraps around the rack post and secures the slide-rail assembly.

Figure 8-2

Attach the second slide-rail assembly to the opposite side of the rack. Ensure that the two slide-rail

assemblies are level and at the same height with each other.

Pull the inner slide rails on each assembly out toward the rack front until they hit the internal stops

and lock in place.

Insert the server into the slide rails:

Step 3

The mounting pegs that protrude through the rack-post holes are designed to fit round or square

holes, or smaller #10-32 round holes when the mounting peg is compressed. If your rack has

#10-32 rack-post holes, align the mounting pegs with the holes and then compress the

spring-loaded pegs to expose the #10-32 inner peg.

Attaching a Slide Rail Assembly

Front-left rack post

Front mounting pegs

Slide-rail assembly

Installation and Upgrade Guide for Cisco Secure Access Control System 5.6

Installing the Cisco SNS-3415/3495 Appliance Rack

Length-adjustment bracket

Rear mounting pegs

Rear securing latch

Figure

8-2).

8-3